PotteryBarn Cheswick User manual

Cheswick
Platform Bed
(California King/King)
Assembly Instructions
Pre
-
Assembly:

Please read all instructions carefully before assembling.

For your safety, assembly by two people is recommended.

Remove all parts from the box and lay out on a clear carpe
ted or scratch
-
free work surf
ace. (The
shipping box provides
an ideal work surface), this will avoid damaging any parts during assembly.
Do not dispose of any contents until
assembly is completed to avoid accidentally discarding small
parts.

Use the parts
lists above to identify and separate each of the pieces included.
Parts Included:
Hardware Included:

(2) Headboard and Footboard (A)

(2) Side Rail (B)

(4) Bun
Feet (C)

(1) Center Beam (D)

(3) Center Leg (E)

(30) Slat (F)

(2) Headboard and footboard Th
in Panel (G)

(2) Side Rail Thin Panel (H)

(12) Wood dowel M8 x 30 (I)

(10) JCBC Bolt M6 x 35 (J)

(8) JCBC Bolt M6 x 60 (K)

(18) Spring washer M6 (L)

(10) Small flat washer M6 x 13 (M)

(8) Large flat washer M6 x 16 (N)

(8) Pan Head Screw M4 x 25 (O)

(1)
Allen key M4 (P)
Assembly Instructions:
(1)
Lay
Attach the bun feet (C) with wood dowel (I) and insert the JCBC bolt M6 x 35 (J), spring
washer (L), large flat washer M6 x 16 (N).
Tighten with Allen key (P). (Fig. 1)
(2)
Attach the headboard and footboard (A) t
o side rail (B) with wood dowel (I), Insert the JCBC bolt
M6 x 60 (K),
spring washer (L), large flat washer M6 x 16 (N) into the pre
-
drilled. Tighten with the
enclosed Allen key (P). (Fig. 2)
(3)
Attach the center leg (E) into the center beam (D) and insert JC
BC bolt M6 x 35 (J), spring
washer (L),
small flat washer M6 x 13 (M). (Fig. 3)
(4)
Insert center beam (D) to fix the top and bottom headboard (A). (Fig. 4)
(5)
Put the slat (F), headboard and footboard thin panel (G) and side rail thin panel (H) as show in
the i
llustration. (Fig. 5)
Fig.
2
F
ig.1

Adjusting Levelers:
Due to an uneven floor the furniture may not sit level causing the doors to misalign or the piece to wobble.
If either occurs,
determine which corner is not level. With two people follow
these steps:
(1)
Carefully elevate the item slightly to provide access to the levelers under that corner.
(2)
Turn the levelers until adequate contact will be made with the floor. Gently set down the piece
and check door
alignment and stability.
(3)
Repeat steps unti
l furniture sits firmly and doors are properly aligned.
Care Instructions:

Dust with a clean, soft cloth

Avoid the use of chemicals and harsh cleaning agents
thank you for your purchase
stores | catalog | www.potterybarn.com
Fig.
4
Fig.
3
Fig.
5
Fig.
5
Headboard and footboard
thin (G)
Side rail
thin (H)
Slat
(
F
)
Slat (F)
Platform bed is also designed to be used as a
California King and King bed size bed.