PotteryBarn RECLAIMED BED User manual

Date: 21-October-15 www. potterybarn.com Page 1 of 6
Rev:
PB - RECLAIMED BED

Date: 21-October-15 www. potterybarn.com Page 2 of 6
Rev:
Important Safety Instructions:
• Please read all instructions carefully before assembling.
• For your safety, assembly by two or more adults is strongly recommended.
• Keep instructions for future use.
• Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
Pre-assembly:
• Remove all parts and hardware from the bo and lay out on a clear carpeted or scratch-free work surface, as
this will avoid damaging parts during assembly. The shipping bo provides an ideal work surface.
• Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
• Use the parts and hardware lists below to identify and separate each of the pieces included.
• The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
• The use of power tools to aid in assembly is not recommended. Power tools can damage hardware and split
wood.
Parts Included:
(C1) Headboard 1
(C2) Left Side Rail 1
(C3) Right side rail 1
(C4) Center support 1
(C5) Footboard 1
(C6) Slat roll 1
ardware Included:
(A)
Half moon washer
M8mm
12
(B)
Thread stud bolts
M8 80 mm
12
(C)
He agon Nut
M8mm
12
(D)
Wooden Dowel
Þ10X 30mm
8
(E)
Spanner

Date: 21-October-15 www. potterybarn.com Page 3 of 6
Rev:
Assembly Instruction Steps:
1. Align the side rails perpendicularly (C2/C3 ) to the headboard (C1). Insert and tighten Thread stud bolts (B)
in the insert nut on the headboard (C1) . Insert wooden dowel (D) in the pre- holes on side rail (C2/C3)
2. Insert half moon washer (A) and nut (C) Tighten with spanner (E)

Date: 21-October-15 www. potterybarn.com Page 4 of 6
Rev:
3. Position the central leg (C4B) under the central rail ( C4 A) then attach the center support rail (C4) to
Headboard .The adjustable leveler underneath the central leg can accommodate uneven looring
4. Align the Footboard perpendicularly (C5 ) to the side rails (C2/C3). Insert and tighten Thread stud bolts (B) in
the insert nut on the Footboard (C5) . Insert wooden dowel (D) in the pre- holes on side rail (C2/C3)

Date: 21-October-15 www. potterybarn.com Page 5 of 6
Rev:
5. Insert half moon washer (A) and nut (C) Tighten with spanner (E)
6. Put slat roll (C6) between side rails (C2/C3).
Care Instructions:

Date: 21-October-15 www. potterybarn.com Page 6 of 6
Rev:
• Dust often using a clean, soft, dry and lint-free cloth.
• Blot spills immediately and wipe with a clean, damp, cloth.
• We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
• Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
Than you for your purchase
Stores | catalog