Power Fist 8005680 User manual

1,300 PSI
Pressure Washer
8
80 00 05 56 68 80 0
Owner’s Manual
BEFORE OPERATING THIS EQUIPMENT
PLEASE READ THESE INSTRUCTIONS CAREFULLY

Safety Warnings
Always follow these basic instructions when using this product:
• To reduce the risk of injury, close supervision is necessary when a product is used near
children.
• Know how to stop the product and lower pressures quickly. Be thoroughly familiar
with the controls.
• Stay alert – watch what you are doing, do not operate the product when fatigued or
under the influence of alcohol or medication.
• Keep operating area clear of all persons.
• Do not over reach or stand on an unstable support. Keep good footing and balance at
all times.
• Follow the maintenance instructions specified in the manual.
• This product has a ground fault circuit interrupter built into the power cord plug. If
replacing the plug or cord, use only identical replacement parts.
• Warning: Risk of injection or injury – do not direct discharge stream at anyone.
• Keep all connections dry and off the ground.
Grounding instructions
This product must be grounded. If it malfunctions or breaks down, grounding provides a
path of least resistance for the electric current to reduce the risk of electric shock. This
product has a cord with an equipment-grounding conductor and a grounding plug. The
plug must be plugged into the appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
Danger: Improper connection of the equipment-grounding conductor can result in a risk
of electrocution. Check with a qualified electrician or service personnel if in
doubt as to whether the outlet is properly grounded. Do not modify the plug
provided with the product – If it will not fit the outlet, have a proper outlet
installed by a qualified electrician. Do not use any type of adapter with this
product.
Ground fault circuit interrupter protection
This pressure washer has a ground fault circuit interrupter (GFCI) built into the plug of
the power supply cord. This device provides additional protection from the risk of
electric shock. Should replacement of the plug or cord become necessary, use only
identical replacement parts that include GFCI protection.
Extension cords
Use only 3-wire extension cords that have 3-prong grounding-type plugs and 3-pole cord
connectors that accept the plug from the product. Use only extension cords that are
intended for outdoor use. Never use an extension cord with an electrical rating lower
than that of the product. Do not use damaged extension cords. Examine extension cord
before use and replace if damaged. Do not abuse extension cord, never yank on any cord
to disconnect. Keep cord away from heat and sharp edges. Always unplug the extension
cord from the receptacle before disconnecting the product from the extension cord.

General Safety Regulations
Warning: Follow the maintenance instructions specified in the manual.
Warning: To reduce the risk of electrocution, do not operate the machine during rain or
a storm. Keep all connections dry and off the ground. Do not touch the plug
with wet hands. It is imperative to not permit water to leak into the machine.
Warning: When the machine is turned on, the interior pumps start and continue to run
even if the pressure wand trigger has not been depressed. Running the
machine for more than 3 minutes without depressing the pressure wand
trigger could cause heat damage to the motor and pumps, Please do not leave
the machine running unattended or unused for more than 3 minutes.
Warning: When the machine is running, please maintain a constant water supply.
Operation without water circulation will damage the seals of the machine.
Warning: It is necessary to turn on the spray lance within one or two minutes after the
machine has been started. Otherwise, the temperature of the circulating water
within the machine will become extremely hot, which will cause damage to
the seals inside the machine.
Warning: To prevent the machine from the freezing, do not start and run the machine in
an extremely cold environment.
Warning: This appliance has been designed for only using cleaning water, do not use
corrosive chemicals.
Warning: Do not use the appliance within the range of anyone not wearing protective
clothing.
Warning: Do not direct the jet against yourself or others in order to clean clothes or
footwear.
Warning: Disconnect from the electrical power supply before carrying out user
maintenance.
Warning: To ensure appliance safety please use only original spare parts from the
manufacturer or approved by the manufacturer. Do not use the machine with
damaged parts.

Know Your Pressure Washer
This pressure washer is a multifunctional machine with reliable safety assurance, which
may be used to wash and clean cars, bikes and other outdoor equipment or garden
patios, green houses etc.
Operating Instructions
1. Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
2. Connect nozzle and nozzle extension.
3. Ensure gauze filter is clear of any blockage.
4. Connect the water supply hose.
5. Ensure that the hose has no kinks in it.
6. Turn on water and check for leaks.
7. Depress trigger to allow air to be expelled though the pump and hoses, lock trigger.
8. Plug in machine and turn on side switch.
9. Unlock trigger and use the pressure washer.
Adjustable spray nozzle
Water may be sprayed out from the spray nozzle either linearly (fig 1) or in fan shapes
(fig 2). Turn on the pressure washer first, and then adjust the nozzle.
Figure 1 Figure 2 Figure 3 Figure 4
Water Inlet Screen
The water inlet filter must be inspected regularly, so as to avoid blockage and restriction
in the water supply to the pump (fig 3).
water outlet joint

Storage
The pressure washer should be stored in a frost-free environment.
After long-term storage without operation, water scales may form inside the machine,
making it hard to start again. In such conditions it is recommended to turn off and
disconnect the power supply and rotate the motor by hand several times so as to avoid
excessive current draw on the motor and the power supply (fig 4).
Attaching soap dispenser bottle
Insert metal end of the spray lance into the opening of spray gun (making sure to match
the locking tabs on either side of the spray lance to the notches of the spray gun), Push
in and twist in a clockwise motion to lock spray lance and spray gun together (make
sure there is a tight and secure fitting between both). Insert end of soap dispenser bottle
with the plastic locking tabs into opening of the spray lance. Push in, turn, and lock so
the soap dispenser bottle and spray lance are secure.
Technical Specifications
Model: 5005680
Working pressure: 1,300 PSI
Working flow rate: 1.6 GPM
Rated electrical current: 13 A
Power Supply Voltage: 120 V / 60Hz
Motor Rotation Speed: 3,400 RPM
Max Water Temperature: 122°F
Max pressure inlet water: 58 PSI
Hose Length: 20 ft
Weight: 28-1/2 lbs
Dimensions: 19-1/2" x 12-1/4" x 10-1/2"