Power Fist 8532657 User manual

User Manual
V 3.04 8532657
Please read and understand all instructions before use. Retain this manual for future reference.
2.3 GPM 3,000 PSI
Pressure Washer

2 For technical questions call: 1-800-665-8685
V 3.04 8532657
2.3 GPM 3,000 PSI
Pressure Washer
SPECIFICATIONS
Type Gas pressure washer
Capacity 2.3 gallons per minute (GPM)
Pressure Rating 3,000 pounds per square inch (PSI)
Engine Type Ducar 4-stroke OHV
Engine Displacement 208 cubic centimeters (c.c.)
Horsepower 7 horsepower (HP)
Pump Type Axial
Valve Type Thermal Relief
Wheel Size 10 inches
Wheel Type Pneumatic
Frame Steel
Detergent System Low pressure chemical injection
Additional Info Recoil start, forced-air cooled OHV engine
Contents Spray gun with 24 in. wand
4 quick connect tips (0°, 15°, 40°, soap)
1/4 in. x 25 ft. high pressure hose
Features Brass head pump with sight glass, breather cap and thermal relief valve
Overview Residential Class: We recommend this model for 8 hours or more of use
per week. For applications such as vehicles, decks, siding, driveways,
fencing,boats.
EPA Certification DCDPS.2081DJ-001
IMPORTANT SAFETY PRECAUTIONS
WARNING! Read and understand all instructions before using this equipment. The operator
must follow basic precautions to reduce the risk of personal injury and/or damage to the
equipment. Before allowing someone else to use this equipment, make sure they are aware of all
safetyinformation.

2.3 GPM 3,000 PSI Pressure Washer
Visit www.princessauto.com for more information 3
8532657 V 3.04
WARNING! The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. Common sense and caution are factors
that cannot be built into this product, but must be supplied by the operator.
NOTE: Keep this manual for safety warnings, precautions, operating, inspection, and
maintenanceinstructions.
WORK AREA
1. Operate in a safe work environment. Keep your work area clean and well lit.
2. Do not use in the presence of flammable gases or liquids.
a. Do not use pressurized starting fluids with the unit, because the vapors are flammable.
3. Keep anyone not wearing the appropriate safety equipment away from the work area.
4. The unit should be located as close as possible to the water supply.
5. Locate the unit on a solid and level surface so that the engine and pump crankcase oil
lubricates the components properly.
6. Avoid areas where water can build up in the working area.
7. Locate the unit in a well-ventilated area and away from flammable materials or fumes.
8. Locate the unit so that the operator has easy access to the pressure washer and its controls.
9. Locate the unit so that it is protected from external damage.
10. To prevent damage and excessive hose wear, locate the pressure washer so that the hose
does not cross traffic areas.
PERSONAL SAFETY
CAUTION! Wear protective equipment approved by the Canadian Standards Association (CSA) or the
American National Standards Institute (ANSI) when using the equipment.
1. Head Protection
a. Always wear impact-resistant safety goggles that provide both front and side protection.
b. Wear earplugs or hearing protector earmuffs if the engine or work environment is noisy.
2. Gloves
a. Wear gloves that should provide protection based on the thermal (heat) levels generated
by the unit.
3. Protective Clothing
a. Wear protective clothing designed for the work environment and the engine.
4. Foot Protection:
a. Wear steel-toed footwear or steel toecaps to prevent injury from falling objects.
b. Non-skid footwear is recommended for maintaining proper footing and balance.
5. Control the unit, personal movement, and the work environment to avoid personal injury or
damage to the pressure washer.
a. Keep articles of clothing, jewelry, hair, etc., away from moving parts to avoid
entanglement with the unit. Traumatic amputation or severe laceration could result.
b. Do not operate any tool or machine when tired or under the influence of drugs, alcohol,
or medications.
c. Do not overreach when operating the unit. Proper footing and balance enables better
control of equipment in unexpected situations.

2.3 GPM 3,000 PSI Pressure Washer
4 For technical questions call: 1-800-665-8685
V 3.04 8532657
SPECIFIC SAFETY PRECAUTIONS
1. All users must understand the operation of all controls and learn how to quickly stop the unit
in case of emergency.
2. The engine and exhaust become very hot during operation. Severe thermal burns can occur
on contact, especially with the muffler.
a. Keep the unit at least 3 feet (1 meter) away from buildings and other equipment
duringoperation.
b. Remove accumulated debris from muffler and cylinder area. Combustible debris, such
as leaves, grass, brush, etc. can catch fire if they come in to contact with a hot engine.
c. Allow the muffler, engine cylinder, and fins to cool before allowing the unit to touch
grass-covered or brush-covered unimproved land.
d. Do not operate the engine without the muffler. No muffler or a muffler that leaks can
permit an increased exhaust noise level.
3. Gasoline is extremely flammable and is explosive under certain conditions. Do not smoke or
allow flames or sparks where the unit is refueled or where gasoline is stored. Refuel in a well-
ventilated area with the engine stopped.
a. Do not refuel the unit while the engine is running. Allow the engine to cool for
twominutes before refueling.
b. Fuel vapours are extremely flammable and may ignite after the engine has started.
Make sure that any spilled fuel has been wiped up before starting the unit. If gasoline is
spilled, move the unit away from the area of the spill and avoid creating any source of
ignition until the gasoline has evaporated.
c. Do not operate the engine when an odour of gasoline is present, or other explosive
conditions exist.
4. Do not place anything on the unit while it is running.
5. Do not use this unit on any forest covered, brush covered or grass covered unimproved land
unless a spark arrestor is attached to the muffler.
6. To prevent hand or arm injury, always pull the starter cord rapidly to avoid kickback.
7. Never allow the pump to run for more than a two minute period without operating the gun.
This will cause pump damage due to excessive water temperature and void the warranty.
8. Never run acids or hard caustics (such as lye) through the pump.
9. Always use citrus based detergents. Never use chemicals or agents which are not compatible
with the polyvinyl or neoprene covering of the hose.
10. Never use water with a temperature over 37°C (100°F).
11. Check for leaks. Tighten connections if necessary.
12. Check for missing O-rings in the couplers.
13. Do not let children operate the unit, and do not allow anyone who is unfamiliar with the
pressure washer to operate it without proper supervision.
14. Never remove the warning labels. Pressure washers provide safe and dependable service
if operated according to instructions. Read and understand the owner’s manual before
operating your pressure washer. You can help prevent accidents by being familiar.
NOTE: Safety labels warn you of potential hazards that can cause serious injury. Read them carefully.
Contact Princess Auto if a label comes off or becomes hard to read.

2.3 GPM 3,000 PSI Pressure Washer
Visit www.princessauto.com for more information 5
8532657 V 3.04
HIGH-PRESSURE FLUIDS
1. Wear proper hand and eye protection when searching for a high-pressure leak. Use wood or
cardboard as a backstop instead of hands.
2. Do not place hands or fingers in front of the nozzle.
3. Never point the spray gun at yourself or other persons or animals.
4. Do not attempt to move objects with spray from the pressure washer.
5. In the event of high-pressure spray penetrating the skin, seek medical attention immediately.
CARBON MONOXIDE POISONING
WARNING! Engine exhaust contains carbon monoxide gas - never start or run this engine indoors.
Opening windows and doors is not enough to ventilate the area.
Carbon monoxide is a colourless and odourless gas that is difficult to detect. Carbon monoxide
poisoning results from inhalation of the gas and may be lethal if left untreated. Evacuate all people
to an area with clean air and seek immediate medical attention for any person experiencing the
followingsymptoms:
1. Headache
2. Confusion
3. Shortness of breath
4. Weakness
5. Fatigue
6. Dizziness
7. Unstable gait (stumbling around)
8. Nauseau & vomiting
9. Unconsciousness
10. Flu-like symptoms
NOTE: As a precaution, install a carbon monoxide detector in any work area that has
gasoline-poweredequipment.
TOOL USE AND CARE
1. This pressure washer was designed for a specific function. Do not modify or alter this unit or
use it for an unintended purpose.
2. Do not tamper with the governor springs, the governor links or other parts which may
increase the governed engine speed.
CAUTION: Do not run the unit at excessive speeds. Operating the engine at excessive speeds
increase the danger of personal injury.
3. Maintain the engine with care (see Maintenance).
4. Remove adjusting keys and wrenches from the engine before operation. A wrench or key that
is left attached to a rotating part of the tool increases the risk of personal injury.
5. Do not operate the engine if the air cleaner or the cover directly over the carburetor air intake
is removed.
6. Do not choke the carburetor to stop the engine.
7. Securely hold gun and wand with both hands. Using the equipment with only one hand can
result in loss of control.