Power Tec WB-LS20 User manual

Glue

28

Utility Workbench - Part No. 45
Important Note:
All Parts have a pre-fix part number of 45
All Unmarked Washers and Nuts are 45.25 and 45.26

ASSEMBLY ONE



36
2







35
3
19
 
 






20


28
44
Step 3
Step 1
Weight Rotating Tube No. 10
Using Bolt 10.8, Washer No. 10.3 and Nut No. 10.4
Place Pulley Wheel No. 10.2 over cable and Install it to
Install Weight Rotating Tube No. 10 to Up-Right Tube No. 6
Using Bolts No. 33, Washers No. 41 and Nut No. 43
Install Steel Axis No. 44 to Up-Right No. 6
Using Bolt No. 31
Install Weight Horns No. 18 to Weight Rotating Tube No. 10
Using Bolts No. 28and Nuts No. 42
Step 2

Step 1
Install Safety Spotter Bar No. 16 onto Up-Right No. 6
Install Press Arms No. 7 and No. 8 onto Steel Axis No. 44
Secure Press Arms to Steel Axis using Washers No. 40 and Bolts No. 29
use as Indepengent Press Arms - Isolateral.
Step 2
Install Weight Horns No. 18 to Press Arms No. 7 and No. 8
Using Bolts No. 28 and Washers No. 42 to secure them.
Note:
Use Press Arms Lock Bar No. 20 to use the Press Arms
as Conventional Press Arms or remove the Lock Bar to
use as Independent Press Arms - Isolateral.

3 26 -20
ASSEMBLY SIX
Utility Workbench - Part No. 45
All parts mentioned on this assembly have a pre-fix Part No. 45
Step1
Install T Handle Spring Pin Part No. 7.2 to Center Main Frame Part No. 3
Step 2
Install Center Main Bench Frame No. 3 to Rear Base Tube No. 1
and to Front Base Tube No. 8 Use Bolts No. 18, Washers No. 25 and Nuts No. 26
Important Note:
Some Parts and Components may come pre-assembled by the factory,
make sure to go over them before finishing assembly.