Power-Tronics PT-1500 User manual

User Manual
PT-1500

CONTENTS
1. Important Safety Instructions.............................................01
2. About the PT-1500 Portable Power Station………………..05
3. Using Portable Power Station............................................07
4. Product Storage and Maintenance....................................14
5. Troubleshooting................................................................ 14
6. Frequently Asked Questions and Answers(FAQ)............. 15
7. Specifications...................................................................17
8. Warranty........................................................................... 18

01
Thank you for purchasing the Powertronics PT-1500 Portable
Power Station. Please contact Powertronics with any product
questions or concerns.
To ensure safety and avoid any property damage, please read
this manual before use, and follow all safety precautions.
Important Safety Instructions
Please be sure to observe the following for safe use
Indicates high temperature, fire or rupture danger while in
operation.
Prohibited activity is described with this icon or by text in or
near this icon.
Represents mandatory operational steps. Specific mandatory
content is described with graphics or text in or near the figure.
DANGER
Please do not disassemble, repair or transform, may cause
electric shock, heat, fire and other dangers.
Do not put the product in fire or near heat source, may cause
fire or burns and other dangers.
Do not operate in wet conditions, rain or inclement weather.
Do not use water to clean the product, itwill cause electric
shock, heat, fire and other dangers.
Do not use metal to bridge AC output interface. It may cause
electric shock, heat, fire and other dangers.
Please dispose of properly. Electricity shock, heat and fire
may occur if improperly disposed of.

03
WARNING
Store in a clean, dry place. Dust, powder and small metal
shavings may cause short circuit, electric shock, smoke, fire
and other dangers.
Be sure to check before use. In case of any abnormality such
as breakage, crack, leakage, heat and AC wire breakage,
please stop using the product immediately.
Supervise children when operating this product.
Disconnect the AC charge cable from the outlet during
lightning storms. Large current spikes from the outlet may
be generated resulting in heat, fire and other damage.
Only charge at the specified voltage range
(AC 100-240V).Otherwise, heat, fire, fire and other damage
may occur..
Note
Stop using the product immediately if anyabnormality such as
rusting, peculiar smell, fever, etc. exists.
Do not allow this product or the AC cable to get wet.
Electric shock, heat, fire and other dangers may occur.
Charge product below 113℉, store product below 149℉
to avoid diminished performance or heat up.
Please carefully read the operating instructions of the
electrical products to be connected.
Be sure to turn off the main power while storing to prevent
unnecessary discharge of the battery and prevent electric
shock.

About the PT-1500 Portable Power Station
1.What’s in the box
PT-1500 ×1
AC Adaptor ×1
Cigarette Lighter cable ×1
Solar adapter Cable x1
User Manual ×1
Note: Pictures are only for reference only
2
1
3
4

06
2.Product Introduction
①②③
⑧ ⑪
1. DC Power Button
2. LED Light Button
3. AC Power Button
8.
LCD Screen
9.
AC Output Port
10.
LED Light
4. DC 12V Car Cigarette Lighter Output Port 11. Reset Hole
5. DC 12V Output Port
6. Type-C PD Output Port
7. USB Output Port
LCD Screen
2
12. Charging Port
1 3
4 5 6 7 8
1. Battery Capacity Indicator 6. TYPE-C ON /OFF
2. Battery Remaining Time 7. AC ON /OFF
3. Input/Output Power 8. 50/60HZ

06
4. DC ON /OFF 9. Overtemperature Indicator
5. USB ON /OFF 10. Fan Indicator

07
149℉
LCD Battery Display:
The LCD Battery Display indicates the charge level and the
remaining capacity.
When charging, you will notice a battery segment blinking with 1
second interval.
This indicates the current charge status and the number under
INPUT shows the real-time charging power. Once it is fully
charged, all battery segments will be lit and remain solid.
Overtemperature indicator Display:
When the discharge temperature is greater than degrees,
the over-temperature protection indicator will be displayed on the
screen for 5 seconds.
Radiator indicator Display:
The fan will turn on when the power supply internal temperature
reaches 45 degrees.
Using Portable Power Station
Important Tips Before Use
Note: Please charge the product to 100% before using.
When charging the product, the battery capacity display icon on
LCD screen will be on dynamic status, after the battery is
charged fully, the display icon will switch to static status.
1 Charging
(1). AC Charger Charging
Note: Always use the standard AC charger that comes with
the product.

08
2
Connect the product and socket with the AC charger in the
package.
Unplug the charger when charging is completed. (it takesabout 8-
10hrs to fully charge the product if using 360W AC
adapter charger )
Please use our adaptor, non-standard adapters may cause
defects in the product.
Note: It is normal for this product to get hot during charging.
Note: Make sure that the wiring is in good contact, otherwise
the contact terminals may melt at high temperatures.
(2) . 12V Car Charger Charging
Connect the product and the cigarette lighter socket with the
cigarette lighter cable in package.
Charge the product after starting the car.
Note: Make sure that the wiring is in good contact,
otherwise the contact terminals may melt at high temperatures.
Note: The car needs to be started before it can charge the
product, otherwise it may run out of battery power.
(3) . Solar Panel Charging
1
2
3
1

09
Please note: Solar panels need to be purchased separately.
Choose suitable solar panels (voltage 12~24V / Max. 200W)
Use the solar panel under direct sunlight, face to the sun
positively.
Connect the solar panel to the PT-1500 with the Solar Charge
adapter cable.
When the product is fully charged it will stop charging
automatically. Please disconnect the charging cable, and turn
off our product.
Note: Please make sure the cable connecting is correct and
stable, or will cause the connector a high temperature status or
sparking.
Note: Please charge the product under 32-113℉ temperature
environment.
Note: During the charging, it is normal situation if the product is
getting a little bit hot.
Note: The charging time is different when light intensity is
different.
Note: If you choose the solar panel which is with MC4 connec-
tor, please make sure the positive and negative poles of solar
panels are connected correctly. Refer to the following connection
chart.
Solar panel PV+
Connecting cable PV+
Solar panel PV-
Connecting cable PV-
1
2
3
4