Prem-I-Air EH0516 User manual

EH0516
12" Desk Fan
3 Speed settings
Oscillation function
Adjustable head
Remote control
Page 1

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
ASSEMBLY.
Hold the fan by the head assembly and remove the pole nut.
Place the head assembly in the base, and press firmly into
position. The replace the pole nut.
Unscrew the plastic nut from the motor housing. Locate the
rear guard on the motor housing - the two holes in the guard
align with the two round pegs on the motor housing. Push the
guard firmly into place and secure with the plastic nut.
Insert the motor shaft through the blades, aligning the pin on
the motor shaft with the slot on the back of the blades.
Secure the blades in place with the spinner. Rotate anti-
clockwise to tighten - it has a left-handed thread.
Check that the blades are free to rotate.
Attach the front guard to the rear guard using the clips built
into the front guard.
Using a screwdriver, secure the two parts of the guard
together with the screw and nut provided.
Page 2

OPERATION
• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead
is rated at 3 Amps or more, and that it is fully unwound.
• Switch the appliance on at the mains socket.
• Turn the rotary switch to the speed required:
Low Speed = 840 m3/h airflow
Medium Speed = 900 m3/h airflow
High Speed = 960 m3/h airflow
• Oscillation is selected by pressing the oscillation knob
downwards (see diagram on page 2), and switched off by
pulling it upwards
• It is normal for the motor to become warm in normal use.
• Unplug the appliance from the mains when not in use.
OPERATING COSTS
At time of going to press, the average cost of electricity is
£0.11 per unit (kilowatt-hour). The amount you are being
charged will be shown on your electricity bill. At this cost, the
EH0516 will cost 8p per day to run on the "low speed"
setting, 10p per day on the "medium speed" setting or 12p
per day to run on the "high speed" setting.
Page 3

PRODUCT SAFETY
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not
play with the appliance
• Do not use in close proximity to gas appliances
• Do not use unless correctly installed.
• Do not cover when in use.
• Do not place the mains lead beneath a carpet or rug.
• Do not use the appliance in locations where paint, petrol or
other flammable liquids are used or stored.
• Do no insert any object into the appliance through the
grilles. This may damage the appliance or result in
overheating or electric shock.
• Do not use this appliance in the immediate surroundings of
a bath, a shower or a swimming pool.
• The appliance is fitted with an overload cut-out which will
operate if the motor overheats or is stalled. If this happens,
disconnect from the mains supply immediately, and allow the
motor to cool down.
Page 4

PAT TESTING
When used in an office environment, this product must be
safety-tested yearly by a qualified electrician (PAT Tested) in
order to comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a
domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified
electrician at least once every 10 years or at every change of
occupancy.
For office and retail premises, and buildings such as village
halls, the wiring must be inspected at least once every 5
years.
It is recommended that all building be fitted with smoke
alarms (it is mandatory for new buildings).
Page 5

MAINTENANCE
Before cleaning, turn the appliance off, and disconnect from
the mains supply. The appliance may then be cleaned using
a damp cloth with a drop of washing-up liquid to remove any
dust or dirt from the case. Do no use stronger detergents or
solvents as these may damage the paint finish.
Using a dry 1" (25mm) paint-brush, remove any dust from the
grilles.
If the mains lead is damaged, it must be replaced by the
manufacturer or and authorised service centre.
If the mains plug needs to be replaced, proceed as follows:
• Connect the brown wire to the terminal labelled "L".
• Connect the blue wire to the terminal
labelled "N".
• Connect the green/yellow wire to the
terminal labelled with the earth symbol
or "E".
• Make sure that the cord-grip is
positioned correctly (over the outer
sheath of the cable) and it fully
tightened.
Neutral
(Blue) Live (Brown)
Fuse
3A
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic
household waste.
Most local authorities have specific collection system for
appliances and disposal is free of charge to the end-user.
When replacing an existing appliance with a similar new
appliance your retailer may take the old appliance for
disposal.
Page 6

TECHNICAL SPECIFICATION
Dimensions: 500×345×270 mm
Weight: 2.1 kg
Power supply: 230V ~
Power consumption: high speed: 40 W
medium speed: 35 W
low speed: 30 W
Air flow high speed: 960 m3/h
medium speed: 900 m3/h
low speed: 840 m3/h
Operating current: high speed: 0.175 A
medium speed: 0.15 A
low speed: 0.13 A
Page 7

SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in
materials and workmanship for a period of twelve months.
Should this appliance be operated under conditions other
than those recommended, at voltages other than the voltage
indicated on the appliance, or any attempts made to service
or modify the appliance, then the warranty will be rendered
void.
The product you buy may sometimes differ slightly from
illustrations. This warranty is in addition to, and does not
affect, your statutory rights.
If you have any problems with this product, please call our
Help Desk on [phone].
Prem-i-Air Appliances Ltd.,
Lancots Lane, Sutton,
St. Helens, Merseyside.
WA9 3EX
website: www.prem-i-air.com
Page 8