Prem-I-Air EH1676 User manual

EH1676 - 8” (20cm) 3 Speed Air Circulator
EH1678 - 12” (30cm) 3 Speed Air Circulator
EH1680 - 16” (40cm) 3 Speed Air Circulator
User Manual
Please Retain for Future Reference

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for future reference.
PRODUCT SAFETY
• This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• For indoor use only.
• Do not use in bathrooms, wet rooms or other damp locations.
• The use of this product in boats, caravans, mobile homes or other similar locations is forbidden
• There must be a minimum 300mm safe area around the sides of this product that must be clear of
obstructions and ammable materials
• Do not place the mains lead beneath a carpet or rug.
• Do not use this appliance in locations where paint, petrol or other ammable liquids are used or stored.
• Please ensure the appliance is switched o and unplugged when not in use.
• Do not use the appliance for other than its intended use.
• Do no insert any object into the appliance through the grilles. This may damage the product or result in
overheating, electric shock, damage or injury.
• Check the product and the mains plug before use for damage. If any damage is detected stop using it
immediately and consult your supplier.
• Only use this product on a at, stable surface.
• Do not leave this product unattended when in use.
• For domestic use only
• There are no user serviceable parts in this product
• Do not use near curtains or other loose items that could become entangled in the blades.
• Do not move or knock this product while in use. Risk of Electrical Shock
• This appliance is tted with an overload cut-out which will operate if the motor overheats or is stalled. If
this happens, disconnect from the mains supply immediately and allow the motor to cool down.
• Do not obstruct the grilles at the front and back of this product
• This product must only be used in an upright position.
• Children less than 3 years should be kept away unless continuously supervised
OPERATION
• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead is rated at 3 Amps or more, and that it is
fully unwound. If any other appliances are connected to the same extension lead, make sure that it is
rated for the total power of all appliances connected.
• Switch the appliance on at the mains socket.
• Use the rotary switch to select the speed required:
O = OFF
1 = low speed
2 = medium speed
3 = high speed
• It is normal for the motor to become warm when in use.
• Unplug the appliance from the mains supply when not in use.

WALL MOUNTING (OPTIONAL)
The fan should be wall mounted by a competent
person.
The fan must be situated close to a mains socket,
on a at stable section of wall and clear of any loose
objects or curtains that may become drawn into
the grille. The unit comes supplied with screws and
plugs designed for use with a solid masonry wall,
if the fan is to be mounted on any other surface
then appropriate xings should be purchased or
a qualied person should be employed to ensure
correct xing.
• Draw a level straight line on the wall and mark with
2 points 238mm apart (see g. 1), the fan should
only be mounted with the bracket horizontal and
not at an angle.
• Drill the 2 holes using an appropriate drill for the
plugs and screws that are to be used to mount the
fan. Insert and tighten the screws leaving a gap of
19mm to the wall (see g. 2).
• Sit the fan on the screws and lower onto the key
slots. Tighten the 2 screw to securely fasten the fan
to the wall.
• Adjust the fan as necessary.
The screws should be routinely inspected to
ensure that they are tight and the fan has not
worked loose during use.
Fig. 1
Fig. 2
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.15 per unit (kilowatt-hour). The amount you
are being charged will be shown on your electricity bill. At this cost, the EH1676/EH1678/EH1680 will cost
9.3p/11.5p/12.6p per day to run on the“low speed” setting, or 12.9p/17.2p/18.7p per day to run on the
“high speed” setting.
PAT TESTING
When used in an oce environment, this product must be safety-tested yearly by a qualied electrician
(PAT Tested) in order to comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualied electrician at least once every 10 years or at
every change of occupancy.
For oce and retail premises, and buildings such as village halls, the wiring must be inspected at least
once every 5 years.
It is recommended that all building be tted with smoke alarms (it is mandatory for new buildings).

The unit is supplied with a moulded plug, if the plug should become
damaged and needs to be replaced, proceed as follows:
• Connect the brown wire to the terminal labelled “L”.
• Connect the blue wire to the terminal labelled“N”.
• Connect the green/yellow wire to the terminal labelled with
the earth symbol or “E”.
• Make sure that the cord-grip is positioned correctly (over the
outer sheath of the cable) and it fully tightened.
PAT TESTING
When used in an oce environment, this product must be safety-tested yearly by a qualied electrician
(PAT Tested) in order to comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualied electrician at least once every 10 years or at
every change of occupancy.
For oce and retail premises, and buildings such as village halls, the wiring must be inspected at least
once every 5 years.
It is recommended that all building be tted with smoke alarms (it is mandatory for new buildings).
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste.
Most local authorities have specic collection system for appliances and disposal is free of charge to the
end-user.
When replacing an existing appliance with a similar new appliance your retailer may take the old
appliance for disposal.
MAINTENANCE
Before cleaning, turn the appliance o, and disconnect from the mains supply. The appliance may then
be cleaned using a damp cloth with a drop of washing-up liquid to remove any dust or dirt from the case.
Do no use stronger detergents or solvents as these may damage the paint nish.
Using a dry 1” (25 mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or and authorised service centre.

SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of twelve
months.
Should this appliance be operated under conditions other than those recommended, at voltages other
than the voltage indicated on the appliance, or any attempts made to service or modify the appliance,
then the warranty will be rendered void.
The product you buy may sometimes dier slightly from illustrations. This warranty is in addition to, and
does not aect, your statutory rights.
Our guarantee is administered by our retailers.
If your product arrives damaged, you must contact the retailer from whom you bought it. The retailer’s
contact details will be on the invoice that arrived with the product, or on the e-mail you received when
you placed the order. Do not contact Prem-i-air, only your retailer can arrange a replacement.
If your product fails within the guarantee period, rstly read the “fault nding” section of this manual,
because temperature and weather conditions can aect the performance of certain products. If the
product needs to be repaired or replaced, you must contact the retailer from whom you bought it.
The retailer’s contact details will be on the invoice that arrived with the product, or on the e-mail you
received when you placed the order.
If you have just received your product and require technical help in using it, please call our Help Desk on
[phone]
If you have any other technical queries about the product, please call our Help Desk on [phone].
Prem-i-Air Appliances Ltd.,
Lancots Lane, Sutton,
St. Helens, Merseyside.
WA9 3EX
Website: www.prem-i-air.com
TECHNICAL SPECIFICATION
EH1676 EH1678 EH1680
Dimensions (mm) 290x120x296 430x167x420 502x225x515
Weight (kg) 1.4 2 2.9
Power (Low Speed) (W) 26 35 32
Power (Medium Speed) (W) 30 40 38
Power (High Speed) (W) 36 48 52
Air Flow (High Speed) (m3/min) 14.1 16.31 30.7
Operating Current
(Low Speed) (A) 0.108 0.145 0.133
Operating Current
(Medium Speed) (A) 0.125 0.166 0.158
Operating Current
(High Speed) (A) 0.15 0.2 0.217
Air Speed (max.) (m/s) 3.97 3.27 3.96
Service Value (m3min/W) 0.44 0.38 0.62
Noise (max) (dB(A)) 61 57.2 62.7