Prem-I-Air EH1797 User manual

EH1797
Prem-I-Air 16” (40 cm)
White Oscillating
Pedestal Fan
with 3 Speed
Settings (PAIR)
User Manual
Please Retain for Future Reference

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for future reference. The
product and it’s mains lead should be inspected before use for signs of damage.
Do not use if there are any signs of damage, and consult your supplier for advice.
PRODUCT SAFETY
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• Do not use in close proximity to gas appliances
• Do not use unless correctly installed.
• Do not cover when in use.
• Do not place the mains lead beneath a carpet or rug.
• Do not use the appliance in locations where paint, petrol or other ammable liquids are used or stored.
• Do no insert any object into the appliance through the grilles. This may damage the appliance or result in overheating or
electric shock.
• Do not use this appliance in the immediate surroundings of a bath, a shower or a swimming pool.
•The appliance is tted with an overload cut-out which will operate if the motor overheats or is stalled. If this happens, disconnect
from the mains supply immediately, and allow the motor to cool down.
1. Front Grille
2. Fan Blade Nut
3. Fan Blade
4. Grille Mounting Nut
5. Rear Grille
6. Crank Shaft
7. Motor Housing
8. Oscillation Control Knob
9. Fan Body
10. Fixing Screw
11. Height Adjustable Pole
12. Pole Cover
13. Base Tube
14. Base
15. Base Cover
IDENTIFICATION OF PARTS
2
9
10
11
12
13
15 14

ASSEMBLY
1. Insert the base tube (13) into the base (14) then insert the screws in the underside to secure
2. Slide the base cover (15) over the base tube (13) down to the base (14)
3. Slide the pole cover (12) over the height adjustable pole (11)
4. Slide the fan body (9) onto the height adjustable pole (11)
5. Slide the rear grille (5) over the crank shaft (6) and attach to the motor housing (7)
6. Secure the rear grille (5) by attaching the grille mounting nut (4) and turning tightly clockwise
7. Slide the fan blade (3) over the crank shaft (6) and secure with the fan blade nut (2), turning tightly anti-clockwise
8. Place the front grille (1) on the rear grille (5) and secure using the clips attached to the front grille (1)
OPERATION
• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead is rated at 3 Amps or more, and that it is fully unwound.
• Switch the appliance on at the mains socket.
• Use the push-button switches to the speed required. 0=OFF, 1=LOW SPEED, 2=MEDIUM SPEED, 3=HIGH SPEED
• Oscillation is selected by pressing the oscillation control knob (8) downwards and switched o by pulling it upwards
•To adjust the fan head angle switch o the unit and disconnect from the mains. Gently push the fan head forwards or backwards
until the desired angle is achieved.
• It is normal for the motor to become warm in normal use.
• Unplug the appliance from the mains when not in use.
3
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-hour). The amount you are being charged
will be shown on your electricity bill. At this cost, the EH1797 will cost 14.4p per day to run on the highest setting.
PAT TESTING
When used in an oce environment, this product must be safety-tested yearly by a qualied electrician (PAT Tested) in order
to comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualied electrician at least once every 10 years or at every change of
occupancy.
For oce and retail premises, and buildings such as village halls, the wiring must be inspected at least once every 5 years.
It is recommended that all building be tted with smoke alarms (it is mandatory for new buildings).
MAINTENANCE
Before cleaning, turn the appliance o, and disconnect from the mains supply. The appliance may then be cleaned using
a damp cloth with a drop of washing-up liquid to remove any dust or dirt from the case. Do no use stronger detergents or
solvents as these may damage the paint nish.
Using a dry 1” (25 mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or and authorised
service centre.
If the mains plug needs to be replaced, proceed as follows;
• Connect the brown wire to the terminal labelled “L”.
• Connect the blue wire to the terminal labelled“N”.
• Make sure that the cord-grip is positioned correctly (over the outer sheath of the cable) and
it fully tightened.

4
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste.
Most local authorities have specic collection system for appliances and disposal is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your retailer may take the old appliance for disposal.
TECHNICAL SPECIFICATION
Dimensions:........................................................... 1250x610x610mm
Weight:...............................................................................................2.5kg
Power Supply:................................................................................230V~
Power Consumption: ......................................................... 50W (max)
Air Flow: ......................................................................3207 m3/h (max)
Operating Current:........................................................................ 0.22A
Air Speed: ....................................................................................2.37 m/s
Noise: ................................................................................................64dBA
Service Value:............................................................... 1.27 m3/W.min
SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of 2 years.
Should this appliance be operated under conditions other than those recommended, at voltages other than the voltage
indicated on the appliance, or any attempts made to service or modify the appliance, then the warranty will be rendered void.
The product you buy may sometimes dier slightly from illustrations. This warranty is in addition to, and does not aect, your
statutory rights.
If you have any problems with this product, please call our Help Desk on [phone].
Prem-i-Air Appliances Ltd., Lancots Lane, Sutton, St. Helens, Merseyside, WA9 3EX
Website: www.prem-i-air.com