Premier LV183194BK User manual

90cm LED Starburst Snowflake
Indoor/Outdoor Use
Catalogue No: LV183194BK, LV183194G, LV183194S, LV183194W
Thank you for purchasing this product. Please read the instructions and warnings carefully before use to ensure safe
and satisfactory operation.
This product can be used in complete safety both indoors and outdoors, but please ensure that the transformer is
plugged into the mains supply indoors and not outdoors, or in damp conditions.
INSTRUCTIONS FOR USE:
• This product is fitted with Light Emitting Diodes (LEDs) connected in a series and parallel arrangement.
• Carefully remove from packaging taking care not to damage or twist the wires.

   

 
PRODUCT ASSEMBLY
• Insert the branch part into support frame and tighten the screws by wrench one by one.
• Extend each starburst carefully to make a beautiful and grand style as you like.
• Make sure to hang the Product on the wall through the hole in the middle, each hole on the top branch
is only for auxiliary suspension. To fix the product on the wall through all the hole on the items if
possible.
• Connect the plug to the transformer.

The light colour of this product is outside the limits as defined in ErP Regulations and therefore only suitable
for decorative purposes.
For replacement parts email: [email protected]
Complies with safety requirements of BS EN 60598
Manufactured & imported by:
Premier Decorations Ltd
UK: HA4 0EJ
EU: Inniscarra D24 EO29

• Make sure that the cable is completely unravelled and that there are no snags in the cable.
• To operate, plug the transformer into mains supply, indoors.
TIMER:
• Plug in to switch ON the lights and to activate the 10 hours ON, 14 Hours OFF timer. The button will
light up green to indicate Timer is active.
•Press the button to switch OFF the lights and the Timer.
•Press button to switch the lights ON and to activate the Timer.
LEDs:
• Non-replaceable Light Emitting Diodes (LEDs): Rating – 3V 0.018W
TRANSFORMER:
• This product is supplied with a DC 31V 12VA transformer and should only be used with this transformer.
FOR SAFETY’S SAKE:
• It is very important that the product is NEVER DIRECTLY connected to the mains supply without using
the transformer.
• Do not completely cover the LED with decorations and other flammable materials. Ensure adequate
airflow around each LED.
• Do not damage the insulation of cable or LED holder.
• Do not secure the wiring of the product with staples or nails.
• Do not close doors or windows on the wiring as this may damage the wiring insulation.
• Do not lay the cable under carpet or where it can be damaged.
• Ensure that cables are fully unwound and sited where they will not become damaged or present a
tripping hazard.
• Do not connect this product electrically to any other product.
• Do not connect the product to the mains supply while it is in the packaging.
• Do not allow any plastic part to come into contact with heat or flame.
• Do not unscrew or twist the LED.
• Do not submerge the product in water (e.g. puddles, guttering and ponds).
• Transformers will become warm during use so should be positioned on flat, stable and heat resistant
surfaces.
• Unplug the product when leaving the house, when retiring for the night or if left unattended.
• Do not overload wall sockets. Use different sockets around the house to plug in multiple lights to
balance the load.
• For decorative purposes only. Not suitable for use in play by children.
• Please retain this information for future reference.