Premium Poly Patios AD-0116 User manual

REV02-6/19
COASTAL SINGLE SWING
AD-0116
1 AD-0116 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com

A
B
C
E
a b c d
e
Suggested Tools:
Drill, Plastic Mallet
F
G
H
D
I
f g
h
PARTS
PART DESCRIPTION PART NO. QTY
A LEFT BACK LEG ASSEMBLY SA-00108 1
B LEFT FRONT LEG ASSEMBLY SA-00107 1
C RIGHT BACK LEG ASSEMBLY SA-00109 1
D RIGHT FRONT LEG ASSEMBLY SA-00056 1
E UNDER ARM SUPPORT PRT-00146 2
F LEFT ARM ASSEMBLY SA-00110 1
G RIGHT ARM ASSEMBLY SA-00111 1
H SEAT ASSEMBLY SA-00104 1
I BACK ASSEMBLY SA-00069 1
HARDWARE
PART DESCRIPTION PART NO. QTY
a #8 X 2" TORX SCREW H-0000-S82 2
b #8 X 2-1/2" TORX SCREW H-0000-S825 4
c 5/16" X 1-1/2" CHAIR BOLT H-0000-CB51615 2
d 5/16" X 2-1/8" CHAIR BOLT H-0000-CB516218 6
e DOUBLE SCREW H-0000-DS 4
f T20 & T25 TORX BIT H-0000-CTD 1
g ROPE CLAMP H-0000-RC 4
h QUICK LINK H-0000-QLPS 2
i 8FT SWING ROPE-NOT SHOWN H-0000-SR 2
AD-0116 Assembly 2
1-877-904-1234
www.Poly-Lumber-Furniture.com

A
B
F
e
x2
T20
E
b
x2
T25
H
d
x6
1.
Attach Parts A & B to Part F by
inserting Hardware e into the pre-drilled
holes and rotating clockwise, stopping
when the assembly is tight
3.
Repeat Steps 1 & 2 with Parts C, D, E, G
2.
Place Part E into the pre-cut slot &
attach it with Hardware b
Please read entire instructions
before beginning
4.
Attach Part H to the previous
assemblies using Hardware d, this step is
made easier if assembly is upside down
3 AD-0116 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com

I
T20
T25
a
x2
c
x2
5.
Slide Part I into place and
attach it using the hardware shown
Rope Assembly
1)
At the center of each rope tie
the knot seen in image 1 with
Hardware h.
2)
Feed the ends of one rope
through the two holes of one
arm. Pass the rope ends through
one eyebolt each and install the
clamp (Hardware g) in image 2 by
removing the screws, opening it
up, inserting the rope, closing
and replacing the screws as
shown.
1 2
4 AD-0116 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com