Premium PRF31500MW User manual

MODEL:PRF31500MW
PRF31600MS

1

Temperature control
Glass Shelves
Vegetable and fruit crisper
bottle rack
2
Keep ventilation openings, in the appliance enclosure or in
the built-in structure,clear of obstruction.
Do not use mechanical devices or other means to accelerate
the defrosting process,other than those recommended by
the manufacturer.
Do not damage the refrigerant circuit.
The appliance has to be unplugged after use and before
carrying out user maintenance on the appliance.
Do not use electrical appliances inside the food storage
compartments of the appliance,unless they are of the type
recommended by the manufacturer;

This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Do NOT use extension cords.
Danger:Risk of child entrapment. Before you throw
away your old refrigerator or freezer:
·
·
·
·
·
·
Take off the doors
·Leave the shelves in place so that children may not easily
climb inside
INSTALLING YOUR REFRIGERATOR
UNPACKING YOUR REFRIGERATOR
·Remove tape and any labels from your refrigerator before
using (except the rating label).
·To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and
WARNING:Use two or more people to move refrigerator.
Failure to do so may result in back or other injury.
3

dry.
·Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator.
·When moving the refrigerator, do not tilt i t beyond 45°
from upright position.
CLEANING BEFORE USE
After you remove all of the packaging materials, clean the
inside of your refrigerator before using it.
SPACE REQUIREMENTS
WARNING: Keep flammable materials and vapors, such
as gasoline, away form refrigerator.Failure to do so can
result in death,explosion, fire or burns.
·To ensure proper ventilation for your refrigerator, allow for
200mm space on each side between walls, 100mm space
between the back of your refrigerator and the wall, and 300mm
space between the top and the cabinet or ceiling.
·If you are installing your refrigerator next to a fixed wall,
leave enough space on the hinge side to allow for the door
to swing open.
·Never install your refrigerator near a heat source or direct
sunlight.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE AN EXTENSION CORD.
4

may
5

6

When using the refrigerator-freezer for the first time or after
defrosting, turn the temperature control to set “MAX” for at
least two hours before introducing the food to be stored. All
frozen food products you purchase should be placed in the
freezer compartment as soon as possible to avoid the frozen
food from defrosting.
Storage recommendation printed on the packaging of frozen
food by the manufacturers should always be followed.
Be careful that the drawer mustn’t mangle the refrigeration
pipeline.
Changing the Light Bulbs
·Unplug refrigerator or disconnect refrigerator from power
supply before you remove the bulb.
·Replace the bulb with 10-watt appliance bulb. Not all bulbs
will fit your refrigerator. Be sure to replace the bulb with one
of the same size and shape.
·
Power Interruptions
If the electricity in your house goes off for a short period,
please keep both doors closed to help foods stay cold and
frozen.
If the power will be out for a longer period, remove foods from
the freezer and stored in a frozen food locker.
7
Plug in or reconnect the refrigerator to the power supply.

8
Frozen Food Storage

taste transfer throughout the refrigerator, and also dry out
frozen food.
Note: Never put bottled food or drinks in the freezer
compartment.
For best performance, leave enough space in the freezer
and refrigerator compartment for air to circulate around
the packages. Also let enough room at the front so the door
can close tightly.
Defrosting
Refrigerator compartment – The defrosting process is
automatic by thermostat
Melted frost flow into drip
tray and automatic
evaporates..
Freezer compartment – Defrosting for the freezer
compartment is by manual
process.
·Turn the thermostat knob to OFF position and leave the
the freezer door open.
·Remove all foods, ice cube tray and shelves or transfer to
the refrigerating compartment.
·Clean and wipe out the melted frost with a cloth.
·After defrosting, turn thermostat knob to origin position.
Note:To avoid damaging to the freezing compartment wall,
do not use any sharp objects to remove the frost or
separate the frozen food.
9

10

2. Self-Tapping Screws/Bottom Bracket/Foot
3. Slide the door down, away from the hinge pin located on
the top of the door.
11

4. Remove the plastic cover from door hinge first. Then
unscrew the two screws from top bracket and replace on
the other side.
5. To install the bracket on the left side of the appliance,
screw the two screws through the bracket and into the top
of the appliance.Slide the door back on to the top
hinge.Ensure the door is face up.Replace the plastic cover
on the top bracket by pressing down until it clicks into
position.
12

6. Screw the bottom hinge into place on the new
side.Replace the foot on the other side.
7. Check that the door is aligned horizontally and vertically
and that the seals are closed on all sides before finally
tightening the bottom hinge. Readjust the leveling feet.
13

14
Use a clean soft sponge with a mild detergent and warm

on the
doors or do
15
Melted frost leaks inside compartment or on the floor:

properly packaged.
--The control is not set according to the surrounding
conditions.
do
any
16

1
Estimado cliente:
Gracias por haber comprado este refrigerador. Para
asegurarse de que usted está obteniendo los mejores
resultados de su nuevo refrigerador, por favor tome tiempo
para leer las sencillas instrucciones que encontrara en este
folleto.
Por favor, asegúrese de que el material de embalaje se
deseche de acuerdo con los requerimientos ambientales
actuales.
Cuando se deshaga de cualquier equipo de refrigeración,
por favor póngase en contacto con su departamento local
de eliminación de desechos en su eliminación segura.
Este aparato debe ser utilizado solo para los fines previstos.
CUIDADO:
Este aparato no estádiseñado para ser utilizado por personas
(incluidos niños) con capacidades físicas, sensoriales o
mentales reducidas, o sin experiencia y conocimiento, a
menos que hayan recibido supervisión o instrucciones
relativas al uso del aparato por una persona responsable de
su seguridad.
Los niños pequeños deben ser supervisados para asegurarse
de que no jueguen con el aparato.

2
Este aparato no estádiseñado para ser utilizado por
personas (incluidos niños) con capacidades físicas,
sensoriales o mentales reducidas, o sin experiencia y
conocimiento, a menos que hayan recibido supervisión o
instrucciones relativas al uso del aparato por una persona
responsable de su seguridad.
Los niños deben ser supervisados para asegurar que no
jueguen con el aparato.
Si el cable eléctrico estádañado, debe ser reemplazado por
el fabricante, su agente de servicio o por personal calificado
con el fin de evitar un peligro.
NO utilice cables de extensión.
Peligro: Riesgo de encierro para niños. Antes de tirar su viejo
refrigerador o congelador:
• Remueva las puertas
• Deje los estantes en su lugar para que los niños no puedan
entrar fácilmente
INSTALANDO SU REFRIGERADOR
DESEMPACANDO SU REFRIGERADOR
ADVERTENCIA: Use dos o más personas para mover el
refrigerador. El no hacerlo puede resultar en lesiones
en la espalda u otros lugares.
• Retire la cinta adhesiva y las etiquetas de su refrigerador
antes de usarlo (excepto la placa de características). Para
remover los residuos de cinta o goma, frote el área con el