Presentation Switchers PS220 User manual

Page 1PS220 Quick Start Guide
Getting to Know the PS220
Getting to Know the PS220
The graphic below points out key aƩributes of the PS220.
Front View
Back View
Back View
Connections
Connections
Inputs and Outputs. Using the graphic above, connect the source devices to the ports labeled
above as, “Connect Source Devices Here”, and the displays at locaƟon, “Display Outputs”, port.
Connect audio, if applicable.
Power. Connect the DC power supply to the locaƟon, “24VDC”, and the other end to your
110V/VAC power socket. The system LED will illuminate above “24VDC” locaƟon.
Front Vi
ew
Front Vi
ew
Quick Start
Connect Sources Devices Here
IR (Infra-Red) Sensor
Source Selector
Active Source Indicators
Stereo Audio Output
Display Outputs USB Firmware Update
Proximity Sensor Port
Power & Indicator
RS-232 Port
24VDC / 1.5A
Ethernet Port

Page 2 Presentation Switchers, Inc.
Auto-Sense, Auto-Switching
Auto-Sense, Auto-Switching
In many situaƟons a control system is oŌen unnecessary, complicated, costly, and confusing.
When a new device is connected to the PS220 system, it is immediately switched to the display.
This feature is especially useful in board room and collaboraƟve presentaƟon systems.
Selecting a New Source Device to Display
Selecting a New Source Device to Display
To display a new source, press the Source Selector buƩon on the Front of the PS220 repeatedly
unƟl the LED on the AcƟve Source Indicator corresponds to the desired Source Port SelecƟon.
The image should now be visible on the Display Output and can be heard on the Stereo Audio
Output connectors.
Note: SelecƟng an input for a source that is not physcially connected will cause the output
display to indicate that the signal has been lost or disconnected.
Selecting a New Source Device to Display
Selecting a New Source Device to Display
(Using IR Remote)
(Using IR Remote)
From the IR Remote controller, shown below, select the Right or LeŌbuƩons unƟl the desired
Source is selected. If the front panel is viewable, you will see the AcƟve Source Indicator change
when each buƩon is pressed.
Output
connectors
.