Presto Precise Digital Pressure Canner User manual

POSSIBLE CAUSE
ERROR CODES Pressure Canning
•Select canning recipe from Instruction Manual. Prepare jars, lids, and
bands. Prepare food as directed for canning.
•Place removable pot in canner. Put canning rack in pot.
•Pour 3 quarts of water into pot, up to ll line.
•Fully insert power cord and plug into 120VAC wall outlet.
•PRESSURE CAN will ash.
•Press the control knob to select the Pressure Can mode.
•0I0 lights up. Rotate control knob adjusting to specic processing time
for recipe and jar size being used.
•Verify you have set the right program and time.
•Press . INSERT JARS lights up. Fill jars half full with water and place
on canning rack.
•Remove regulator from canner cover.
•Place cover on canner and lock. Conrm gasket is on sensor.
•Lower sensor arm and turn green latch clockwise to lock in place.
•Press . WARM lights up. Jar warming will take about 20 minutes.
At this time, complete food preparation.
•Canner will beep twice and FILL JARS lights up.
•Unlock and lift sensor arm. Remove cover.
•Lift out one jar at a time. Discard water from jar and immediately ll jar
according to canning recipe. Position lid and secure with band.
•Place lled jar on canning rack and repeat until all jars are lled.
•Place cover on canner and lock. Lower sensor arm and turn green latch
clockwise to lock in place. Conrm that regulator is not on the cover.
•Press and HEAT lights up.
•Once the proper temperature is reached, VENT and 0I0 will light up
and the timer will begin to count down.
•When venting time expires, unit will start beeping.
•PUT REGULATOR ON will light up. Using a pot holder, place regulator on
vent pipe, press down and rotate so regulator lever points to CAN position.
•Press
to advance to canning phase. Beeping will stop.
•If the air vent/cover lock did not lift during venting, air/steam will continue
to release until it lifts.
•CAN lights up. The processing time set in phase 1 appears.
•Once the required pressure canning temperature is reached, the unit
will beep twice and CANNING will light up. Timer begins to count down.
Canner is now processing.
•When processing time expires, canner beeps 4 times.
•COOL lights up. Cooling phase may take about 1½ hours.
•When
0I0 lights up, the timer begins the nal cool down.
•When time expires, unit beeps 10 times and DONE lights up.
•Press and hold for 3 seconds. Conrm air vent/cover lock has
dropped. Unlock and lift sensor arm. Remove cover.
•Using a jar lifter, carefully remove jars by lifting straight up. Place jars
upright on a towel. Do not retighten bands. Allow jars to cool naturally.
Check seals no earlier than 12 hours, but no later than 24 hours.
1
Getting
Ready
2
Jar
Warming
3
Fill Jars
4
Venting
5
Canning
6
Cooling
7
Done
CANCEL ADVANCE
CONTROL KNOB
Insucient liquid.
Regulator was not removed from
canner cover in jar warming phase.
Regulator was not removed from
canner cover during venting.
Canning process was
interrupted.
Cooling process was
interrupted.
E3
EI0
E20
E50
E4
E I E2 E5
PRESSURE CANNING METHOD
PRESSURE CANNING METHOD
Quickstart Guide
Digital Pressure Canner
®
E60
Reference Instruction Manual for a detailed
explanation on how to remedy the following
error codes. See Troubleshooting section.
Contact Presto Consumer Service for the
error codes below. Unplug canner. See
Consumer Service Information section in
Instruction Manual.
Regulator was not installed on
canner cover after venting.
E2I
Minimum Mason Jar Capacity: When using
the digital canner for pressure canning, use at
least 2 quart jars, 4 pint jars, or 8 half-pint jars.
Maximum Mason Jar Capacity
JAR TYPE Regular mouth Wide mouth
Half-pints 10 14*
Pints 8 7
Quarts 5 4
*To properly double-deck, see Instruction Manual.
IMPORTANT: Read your Instruction/Recipe Manual carefully before each use for important operating instructions. Once you
have become familiar with how your Presto Precise® Digital Pressure Canner operates, this condensed guide
will become a convenient reference tool.

POSSIBLE CAUSE
Contact Presto Consumer Service for the
error codes below. Unplug canner. See
Consumer Service Information section in
Instruction Manual.
•Select canning recipe from Instruction Manual. Prepare jars, lids, and
bands. Prepare food as directed for canning.
•Place removable pot in canner. Put canning rack in pot.
•Pour 3 quarts of water into pot, up to ll line.
•Fully insert power cord and plug into 120VAC wall outlet.
•PRESSURE CAN will ash.
•Slowly rotate the control knob until BOILING WATER CAN ashes on
display. Press control knob to select Boiling Water Can mode.
•005 lights up. Rotate control knob adjusting to specic processing
time for recipe and jar size (pints or half-pints).
•Verify you have set the right program and time.
•Press . INSERT JARS lights up. Fill jars half full with water and place
on canning rack.
•Remove regulator from canner cover. Never use the regulator when
using the Boiling Water Canning method.
•Place cover on canner and lock. Conrm gasket is on sensor.
•Lower sensor arm and turn green latch clockwise to lock in place.
•Press . WARM lights up. Jar warming will take about 20 minutes.
At this time, complete food preparation and heat at least 3 quarts of
water to boiling in a large kettle for later use. More water will be needed
if canner is not lled to jar capacity.
•Canner will beep twice and FILL JARS lights up.
•Unlock and lift sensor arm. Remove cover.
•Lift out one jar at a time. Discard water from jar and immediately ll jar
according to canning recipe. Position lid and secure with band.
•Place lled jar on canning rack and repeat until all jars are lled.
•Pour boiling water into canner so water level is 1 inch above the jars.
•Place cover on canner and lock. Lower sensor arm and turn green latch
clockwise to lock in place.
•Press . HEAT lights up. The processing time set in phase 1 appears.
•Once the boiling water canning temperature is reached, the unit will
beep twice and CANNING will light up. Timer begins counting down.
•When processing time expires, the canner beeps 4 times.
•COOL and 005 will light up. Timer will begin to count down. At this
time, unlock and lift sensor arm and carefully remove cover.
•When time expires, canner beeps 10 times and DONE lights up.
•Press and hold for 3 seconds.
•Using a jar lifter, carefully remove jars by lifting straight up. Place jars
upright on a towel. Do not retighten bands. Allow jars to cool naturally.
Check seals no earlier than 12 hours, but no later than 24 hours.
©2021 National Presto Industries, Inc. Form 4008-124D
CANCEL ADVANCE
CONTROL KNOB
1
Getting
Ready
2
Jar
Warming
3
Fill Jars
4
Canning
5
Cooling
6
Done
Reference Instruction Manual for a detailed
explanation on how to remedy the following
error codes. See Troubleshooting section.
Regulator was not removed from
canner cover during boiling water
canning phase.
E3
E30
E4
E I E2 E5
EI0
BOILING WATER CANNING METHOD
Quickstart Guide
Insucient liquid.
Regulator was not removed from
canner cover in jar warming phase.
®
IMPORTANT: Read your Instruction/Recipe Manual carefully before each use for important operating instructions. Once you
have become familiar with how your Presto Precise® Digital Pressure Canner operates, this condensed guide
will become a convenient reference tool.
ERROR CODES Boiling Water Canning
Digital Pressure Canner
BOILING WATER CANNING METHOD
Maximum Mason Jar Capacity
JAR TYPE Regular mouth Wide mouth
Half-pints 10 7
Pints 8 7
Quarts do not t in this model. At least 1-inch of water
above jars is required for boiling water canning.