Pro-Elec PEL00309 User manual

29” Tower Fan
Model: PEL00309 & PEL00467
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future
reference.
• When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
• This appliance is intended for domestic use only. It should not be used for
commercial purposes.
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning the use of
the appliance in a safe way and understands the hazards involved.
• Children shall not play with this appliance.
• Cleaning and maintenance shall not be made by children without supervision.
•
personnel.
• Do not operate this fan with a damaged plug or cord, after a malfunction or after
being dropped or damaged in any way.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
• Ensure that the fan is switched off before removing the guard.
• Do not insert anything through the grille when the fan is in use.
• Make sure that the fan is on a stable surface when operating.

ASSEMBLY
OPERATION
• Connect the power plug to a suitable outlet.
• Turn the fan on using the ON/OFF button.
• Select the desired speed by pressing the SPEED button, until the desired speed
LED is lit.
• Turn “swing” on or off by pressing the SWING button.
• Pressing the MODE button will select either “natural” or “sleep” mode.
Remote Control
• The remote control can be used to adjust all of these features remotely by
pressing the corresponding buttons on the remote control.
• The remote requires 2 x AAA batteries (not provided).
• Assemble the base around the cord and align with the posts on the bottom of the
fan. It will drop into position when correctly aligned.
Note: The plug will not t through the hole in the base.
• Using the screws provided, secure the two base halves together (two screws) and
then secure the base to the fan unit (four screws).
• Use the provided cable grip and screws to x the cable in position to prevent it
becoming trapped under the base.
CLEANING & MAINTENANCE
• Before cleaning, switch the fan off and unplug from the power supply.
• To clean the fan, use a soft cloth to wipe off any dust. If the fan is very dirty, use a
damp cloth and wipe dry.
• Do not use any chemicals, abrasives or solvents that could damage the fan.
• Store the fan in its original packaging in a dry, well ventilated area.
• The motor bearings are permanently sealed and do not require additional
lubrication.
TECHNICAL SPECIFICATION
Power consumption 50W
Main voltage 220-240V~ 50Hz
Dimensions 260 x 260 x 810mm
Weight 2.2kg
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling of the
materials used. Contact your local authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.1