Pro Fitness 302/1512 User manual

1
Punchbag Wall Bracket
302/1512
Components - Parts
Components - Fixings
Assembly Instructions
Important: Ensure there are no
electrical cables or water pipes
in the wall before drilling any
holes.
Ensure that the wall or beam
that you attach the Punchbag
bracket to, is of sound
construction.
Mark and drill fixing holes using
a 12mm drill bit. Attach the
bracket and Chain link to the
wall.
The bracket must be fixed to a
solid surface and not a cavity
or plaster board wall.
Ensure the Punchbag bracket
is securely attached before
each use.
Ensure the Punchbag is
securely attached to the Safety
hook.
Each expansion bolt shall
support at least 75kg loading.

2
Part Description Qty
1 Main bracket support 1
2 Angle bracket support 1
3 Sliding bracket 1
4 Locking pin 1
5 Cotter pin 1
6 M10 x 50mm Expansion bolt 5
7 M8 x 60mm Bolt 1
8 M8 Nylon locknut 1
9 M10 Washer 5
10 M8 Washer 2
11 Expansion bolt wall plug 5
12 25mm Square inner cap 3
13 20mm Square inner cap 2
Punchbag Wall Bracket
Exploded Parts Diagram List
Exploded Parts Diagram

3
This product weights about 1.3kg and occupies 0.8 square foot when fully assembled.
The hanging load for this equipment, MUST not be over 100kg.
Check and make sure all parts are fastened before usage.
The product shall be placed and used on a flat wall surface.
The safety level of the equipment can be maintained only if it is examined regularly for damage and wear, e.g.
connection points.
Replace defective components immediately and/or keep the equipment out of use until repair.
Special attention should be paid to components most susceptible to wear.
This machine is not suitable for therapeutic purposes.
Injuries to health may result from incorrect or excessive training.
Keep unsupervised children away from the equipment.
This product is for punchbag training use.
Warnings
Safety Information

4
The free area shall be not less than 0.6m greater than the training area in the directions from which the
equipment is accessed. The free area must also include the area for emergency dismount. Where equipment
is positioned adjacent to each other the value of the free area may be shared.
Customer service address :
ARGOS 489-499 Avebury Boulevard Milton Keynes MK9 2NW.
Warnings
Safety Information