Prorack K121 User manual

K121
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 4 x 4 x 4
Revision No: 3C 1

Fitting Kit K121
MAX kgs (lbs)
W/P WHD
Nissan
Primera, 4dr Sedan 97-01 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Primera, 4dr Sedan Jul 97-01 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
2

Fitting Kit K121
X
A B C 1 2 3
Primera, 4dr Sedan 97-01 (ZA) -320mm 280mm - 776mm 758mm -
-12 -5/8ths" 11" - 30 9/16ths" 29 13/16ths" -
Primera, 4dr Sedan Jul 97-01 (NZ) -320mm 280mm - 776mm 758mm -
-12 -5/8ths" 11" - 30 9/16ths" 29 13/16ths" -
3

Fitting Kit EN
K121
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4

Fitting Kit EN
K121
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5

Fitting Kit EN
K121
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●A = Grey
B = Black
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
6

Fitting Kit EN
K121
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Fit rubber pads (supplied with fitting kit) to
foot.
●Make sure the pad fits into the holes
underneath the foot.
7

Fitting Kit EN
K121
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Clamps directly to edge of roof under the
doors
●Press adjusting screw to adjust the leg
positions on the crossbar.
8

Fitting Kit EN
K121
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
●Tighten locking screw on both legs evenly.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
9

Fitting Kit EN
K121
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10