Prorack K758 User manual

K758
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 2 x 2 x 4 x 4
x 1 x 4
Revision No: 1A 1

Fitting Kit K758
MAX kgs (lbs)
W/P WHD
BMW
1 Series F21, 3dr Hatch 12-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
1 Series F21, 3dr Hatch 12-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
1 Series F20, 5dr Hatch 12-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
1 Series F20, 5dr Hatch 12-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
1 Series F20, 5dr Hatch 12-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
1 Series F20, 5dr Hatch 12-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
1 Series F20, 5dr Hatch 12-+ CN 75 kgs (165 lbs) 75 kgs (165 lbs)
2

Fitting Kit EN
K758
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●This kit fits type A, B, C and D.
●Use keys to remove covers.
3

Fitting Kit EN
K758
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Attaches to factory-fitted mounting points
●Please check the rear of this manual for
information relating specifically to your
vehicle.
●Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
4

Fitting Kit EN
K758
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
5