Prorack K774 User manual

K774
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 4 x 4 x 4
x 4 x 8 x 4 x 2
x 2
Revision No: 1A 1

Fitting Kit K774
MAX kgs (lbs)
W/P WHD
Citroen
C4 Grand Picasso, 5dr MPV 13-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
C4 Grand Picasso, 5dr MPV 14-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
C4 Grand Picasso, 5dr MPV 14-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
2

Fitting Kit EN
K774
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type B crossbar
fitted. They also apply to type A, C and D.
●Use keys to remove covers.
3

Fitting Kit EN
K774
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Set bars to length (revert to rear of these
instructions).
●Please check the rear of this manual for
information relating specifically to your
vehicle.
4

Fitting Kit EN
K774
●Firmly tighten (3 Nm) adjusting screw.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Remove both pins from each leg. Use
tapered end of spanner located inside left
hand cover to assist.
5

Fitting Kit EN
K774
●Detach foot from leg. Store loose parts in a
safe place.
●Select four feet assemblies and match the
left and right assemblies to the left and
right roof rack legs.
●Assemble foot from kit into leg by pressing
it down.
●Ensure foot interlocks with leg.
●Using short capscrew and washer, secure
assembly onto leg (use Hex Screwdriver
supplied with crossbar to assist)
6

Fitting Kit EN
K774
●Apply protective strip as shown.
Trim if required.
●Use two M5 x 12 mm self tapping screws to
secure the assembly onto the leg.
●Do not over tighten.
●Repeat for all legs.
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Make sure there is no interference between
what you intend to carry with aerials,
sunroof or tailgate.
7

Fitting Kit EN
K774
●Slide clamp through opening in leg.
●Ensure the clamp engages correctly in slot
inside of roof rail.
●Thread the coach bolt through the clamp
and the leg.
8

Fitting Kit EN
K774
●Tighten the plastic knob.
●Ensure the plastic knob is in the position
shown when fully tightened.
●Repeat for all legs.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
9

Fitting Kit EN
K774
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10