Proscale SLICK User manual

Thank you for purchasing the Proscale® Slick digital scale. Please read all operating instructions
carefully before use. This electronic scale is a precision instrument. With normal care and proper
treatment, it will provide years of reliable service.
Never load the scale with more than the maximum capacity. Overloading will permanently damage
it! Avoiding any exposure to extreme heat or cold, your scale works better when operated at normal
room temperature. Always allow the scale to acclimate to normal room temperature for at least one
hour before use. Give your scale sufficient warm up time. Usually 30-60 seconds before calibration to
give the internal components a chance to stabilize. Keep your scale in a clean environment. Dust, dirt,
moisture, vibration, air currents and a close distance to other electronic equipment can all cause an
adverse effect on the reliability and accuracy of your scale. Handle with care. Gently apply all items to
be weighed onto tray top. Although this scale is designed to be quite durable, try to avoid rough
treatment as this may permanently damage the internal sensor. Avoid shaking, dropping or
otherwise shocking the scale.This is a precision instrument and must be handled with extreme care.
USER MANUAL

OPERATION
1. Place scale on a horizontal flat surface, press
[ON/OFF] key to turn on the scale.
2. Wait until "0.0" or“0.00”is displayed.
3. Put the object(s) on the weighing platform.
4. Press [UNITS] key to select a weighing unit.
TARE SETTING
1. Turn on scale as described above.
2. Place the "tare item" on the platform.
3. Press [TARE] and wait until "0.0" is displayed.
4. Add the "net-weight-item”.
CALIBRATION
1. Turn on the scale by pressing [ON/OFF] key.
2. Wait until the LCD displays“0.00”and then
press and hold [UNITS] key until the“CAL”is
displayed, and then release the [UNITS] key.
3. Press [UNITS] key again, the LCD will display the
required calibration weight.
4. Place the required calibration weight and wait 3
seconds, the display will show“PASS”and
return to normal weighing mode.
5. Calibration is complete.
DISPLAY ERROR MESSAGES
Change the batteries
Recalibrate the scale as
shown above
You are overloading the
scale. Remove the excessive
load immediately
Use the scale in a more
stable position
[Lo]
[OUE2]
[O_LD]
[UnST]
SPECIFICATIONS
Capacity 100g
Readability 0.01g
Modes dwt, ozt, ct, gn, oz, g
Calibration 100g
Tare Range Full capacity
Auto Off 60 seconds off
Op. Temp 10 to 30 degree C
Power 2x AAA
Scale Dim. 135mm x 82mm x 20mm
Tray 77mm x 67mm

www.smokecartel.com
Online Headshop