Pureit Classic 23L Installation guide

What is the capacity of the 'Pureit Classic 23 litre' water purifier
system?
The top chamber of 'Pureit Classic 23 litre' water purifier has a capacity of 9 litres, and the
transparent chamber of Pureit Classic water purifier has a capacity of 9 litres. This has been
designed such that for a typical family, the water has to be filled in the top chamber only once a
day. However if more than 9 litres of water is required in a day, you can fill the top chamber as
often as necessary and take the corresponding water out of the transparent chamber
How much water can the 'Pureit Classic 23 litre' water purifier
system purify in one day?
Every time you fill the top chamber of a 'Pureit Classic 23 litre' water purifier with water, all of it
will get purified, and will collect in the transparent chamber within a few hours. So you can keep
filling the top chamber as often as you need. However, you must ensure that there is one inch of
empty space left in the transparent chamber, and that you don't then pour any more water into the
top chamber. If you don't do this, or if you forget to withdraw water from the transparent
chamber, the system has been designed to overflow from the side. You may repeat as many
cycles a day as you require.
How long does it take to purify water on Pureit?
The average flow-rate of the Pureit water purifier will depend upon the quality of the water that
is put into the Pureit system, and may also vary with the life of the Pureit Germkill Processor.
The flow-rate through the system will typically be in the region of 30-150 ml/min. This means
that 9 litres of water would get purified in 1-5 hours, depending on the quality of input water.
Please note that the flow rate will be much higher than that in the beginning of the Pureit
Germkill Kit™ life. Whenever you feel that the flow from your Pureit water purification system
has become unsatisfactorily low, you can wash Activated Carbon Filter. Cleaning will remove
accumulated dirt on the Activated Carbon Filter and will improve the water flow. Please follow
Activated Carbon Filter cleaning instructions mentioned in Troubleshooting point 1. It must be
remembered that the first time you use the system, and anytime else when you empty the
Cleansing - Collection chamber (such as after prolonged nonuse) no water will come out into the
transparent section for a few hours. This is because the Cleansing - Collection chamber has to get
re-filled with water.
Will my Pureit water purifier remove salts and oils from
water?
Water may contain many materials which affect the taste of water. Of these, Pureit removes
materials like oil, sand, soil, clay, dirt, decayed animal and plant waste, and harmful pesticides
impurities, and is therefore likely to improve the taste of water. However, Pureit does not remove
some materials that may contribute to taste like sodium chloride salt, calcium and magnesium.

Can one pour brackish water into Pureit?
Yes, the water will be 'as safe as boiled water'™, but there may not always be an improvement in
taste. However by pouring brackish / sea water into the Pureit, there may be a risk of choking the
system.
Sometimes there is a chlorine-like smell near the 'Germkill
Processor', is this a problem?
No, this is not a problem. You will continue to get absolutely safe, odor free, great tasting and
pure drinking water from the transparent chamber.
Water purified from Pureit has distinctive taste?
The first batch of water that gets purified in your new Pureit, or from a new 'Germkill Kit™',
should be drained away when it collects in the transparent chamber. This batch of water may
have a distinctive taste and needs to be drained out by opening the tap. It should be noted that
even though the first batch of water may have a distinctive taste, it is completely safe, even if
accidentally ingested. Once you drain away the first batch, you will get pure and great tasting
water in subsequent batches.