6 7
PUREIT ULTIMA RO + UV WITH OXYTUBE’s
UNIQUE TECHNOLOGY
Sediment Filter
Removes fine and coarse particulate impurities/dirt and improves life of the Carbon Filter.
Pre-RO Carbon Filter
Removes chlorine and organic impurities like harmful pesticides. It also adsorbs bad taste
and odour-causing organic compounds from water.
Post-Carbon Sediment Filter
Removes remaining fine and coarse particulate impurities/dirt and improves life
of RO Membrane.
RO Membrane
Removes dissolved salts, hardness, pesticides and heavy metals like arsenic, lead and mercury.
It also removes microbial contaminants like bacteria, virus, protozoa and cysts.
UV Chamber
Acts as an additional stage of purification to further inactivate bacteria, virus
and parasites to deliver safe water.
TDS Modulator
Adds adequate quantities of essential minerals to the purified water.
Post-RO Carbon Filter
Last level of purification acts as a polisher and enhances the taste of purified water.
OxyTub e
It’s OxyBlast technology removes chemicals and pesticides from the surface
of fruits and vegetables.
1
2
3
4
5
6
7
8
TECHNICAL SPECIFICATIONS OF
PUREIT ULTIMA RO + UV WITH OXYTUBE PURIFIER#
* Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality, TDS,
pressure and life of Filter elements.
** Water storage capacity is 7.5 to 8 litres with running water.
*** Input water quality and TDS content are important determinants of output water quality.
**** If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost. If the pressure
is lesser than 5 PSI then you need to buy ‘Pressure enhancing pump’ at an additional cost. Device should not be installed in a
house where input pressure is greater than 60 psi.
#Technical specifications are subject to change or improvement without prior notice.
6 7
4
1
3
2
5
8
Pureit Ultima RO + UV with OxyTube
Height ~490 mm
Width ~380 mm
Depth ~285 mm
Weight of ‘Pureit Ultima RO + UV with OxyTube’
~10 kg
Flow rate*Approximately 9–12 litres per hour
Storage tank capacity 8 litres**
6-Stage purifying technology
PP melt blown pre-sediment filter, Pre-RO carbon filter, post-carbon sediment
filter, reverse osmosis membrane, UV reactor and post-RO carbon filter
Membrane type Thin-film composite spiral wound
Pump type Diaphragm pump, 24 VDC
% Recovery*Typically 25%
TDS reduction*** 90% (min)
Input water pH range 6.5–8.5
Power rating 55 Watts
Pressure rating 5–30 PSI****
Rated voltage (Operating voltage) 150 – 240 VAC 50 / 60 Hz (150 – 300 VAC) 50 / 60 Hz)
Material of construction for plastic parts Food grade, non-toxic, engineering grade plastics
Length of power cord 1.5 metres
Total dissolved solids in input water Upto 2000 mg/lit
Total hardness of input water 500 mg/lit (max)
Iron in input water 0.3 mg/lit (max)
Turbidity of input water 1NTU (max)
Germkill Kit™
Material of construction Food grade, non-toxic, engineering-grade plastics
Sediment filter Sediment Filter – 1No Dehumidifier Filter – 1 No
Germkill Kit™-1
Sediment Filter – 2 Nos Post-RO Carbon Filter – 1No
Dehumidifier Cartridge - 2 Nos TDS Modulator – 1No
Pre-RO Carbon Filter – 1No
Germkill Kit™-2
Sediment Filter – 2 Nos Dehumidifier Cartridge - 2 Nos
Pre-RO Carbon Filter – 1No RO Membrane – 1No
Post-RO Carbon Filter – 1No TDS Modulator – 1No
Post-Carbon Sediment Filter – 1No
Germkill performance standard Meets stringent international criteria for microbiologically
safe drinking water – e.g., Environmental Protection Agency (EPA), USA
Specifications for OxyTube
OxyTube rating 100 mg/hr
Relative humidity 80% maximum
Input power 24 VDC
Output power 3 kV ; 21-24 kHz frequency
