PureMate PM 60 User manual

IONIC AIR PURIFIER
FOR CAR & VEHICLE
MODEL NO: PM 60
INSTRUCTION MANUAL

Thank you for purchasing the efficient PureMate PM 60 Car air purifier. We wish
you many years of healthy indoor air with this innovative product.
English | 1
Ensure that all safety precautions are followed when using electrical appliances
for the proper operation of the device.
This instruction booklet describes the safety precautions to be observed during
operation to prevent injuries to yourself, other persons and damage to the device.
The content not only is suitable for this product but also suitable for electrical
appliances in general.
SAFETY OPERATION
- This device should be used in 12V DC vehicles only. Do not use in 24V DC vehicles.
- Unplug the unit from the 12-volt cigarette socket when the vehicle engine is running
at low speeds for an extended period. This will prevent damage resulting from sudden
voltage surges from the battery during low load conditions.
- The effectiveness of this device will be reduced when the vehicle windows are open.
- To prolong service life it is advisable to turn off the PM 60 when not operating the
vehicle.
- Keep this device dry. If moisture accidentally enters the unit, please dry it thoroughly
inside and out before using it.
- Clean the PM 60 exterior cover with mild detergent only. Do not use alcohol, benzene
or other strong solvents, as they will do damage to the cover.
SAFETY PRECAUTIONS
- The PM 60 generates thousands of negative ions that bind with allergens, microbes and
other pollutants (including bacteria, cigarette smoke, vehicle emissions, odours, etc.)
removing them from the air, keeping it fresh and clean.
- Fresh air continuously circulating when you drive keeps you alert and comfortable to
prevent fatigue during your trip.
- The compact and mini design allowed the device to be install on the dashboard
without blocking your view.
PRODUCT FEATURES

English | 2
COMPONENTS
ON/OFF switch
Indicator light
Air inlet
Air outlet
DC plug
OPERATING INSTRUCTIONS
- Use the adhesive strip provided to secure the PM 60 firmly on the dashboard with the
six air outlets facing the interior of the vehicle.
- Insert the unit’s DC plug into the cigarette lighter socket. Move the switch, located on
the side of the device, to the [ON] position. The green light will appear when in
operating mode.
- Turn the switch to the [OFF] position to stop operation.
Note: In some vehicles the power to the cigarette lighter socket will cut off when the
vehicle is not operating.
When the effectiveness of the device is obviously reduced or after 2 to 3 months of use,
please clean the device as follows:
1. Unplug from the socket and remove carefully the upper cover. Be careful not to break
the four positioning lock inside the cover.
2. Use cotton bud soaked with alcohol to wipe clean the electrode needles and the dust
collector plate through the holes. Be careful not to damage the internal electronic parts.
3. Wipe dry any leftover moisture and close the cover. The device can start again when
it is thoroughly dry.
CLEANING & MAINTENANCE

English | 3
At the end of the product life cycle, you should not throw this machine
into the normal household garbage but ring the product to a collection
point for the recycling of electrical and electronic equipment.
DISPOSAL OF THIS DEVICE
PRODUCT SPECIFICATIONS
Model PM 60
Rated voltage DC 12V
Power consumption 2W
Negative Ion output Max. 100,000/cm³
Active oxygen output 0.01 ppm - 0.4ppm
Dimensions 14cm(L) x 7.4cm(D) x 3.8cm(H)
Weight 0.4 lbs (180g)