PYROMANIA GWS-25R User manual

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
1 / 8
Package Contents - Parts List:
4x Glass Panels
4x Top Brackets
4x Bottom Brackets with Preinstalled Foot and Pad
16x Screws
16x Sillicone Inserts pads

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
2 / 8
What is Required:
• Phillips Screwdriver (Hand tools ONLY, do NOT use power tools for
assembly)
• Soft leather gloves for handling glass panels
• Soft non-abrasive, sturdy and flat surface for assembly to prevent damage
• 2 people are recommended for assembly and installation
Before You Begin:
Before beginning assembly, make sure all parts are present. Carefully remove the wind
guard from the packaging and inspect for any damage such as chips or cracks. Place
glass panels on a flat surface, grouped together by type of part and compare parts
received with the “Package Contents - Parts List.” If any part is missing or damaged, do
NOT attempt to assemble the product. Please read and understand this entire
installation instructions before attempting to assemble, operate or install this product. If
you have any questions regarding the product, please contact Pyromania Inc. customer
service.

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
3 / 8
Installation:
1. Ensure that each bracket has 2 set screws in them with the silicone insert pads
attached to the back side. Then, assemble 2 panels with top bracket. Make sure
that silicone pads backing remains in place on all screws to prevent cracking or
shattering the glass. Work your way around the panels. Keep the screws loose to
assure that the brackets are positioned correctly.
**HINT: It is recommended to assemble wind guard upside down (as shown)
for ease of assembly and flip over after it is fully assembled.**

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
4 / 8
2. Assemble all panels with remaining top brackets , and tighten only once all of
the brackets and glass panels are properly in place.

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
5 / 8
3. Install bottom brackets. Do not overtighten screws because glass can break.
Tighten until snug.

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
6 / 8
4. Finish securing all screws. Gently secure all screws (on all brackets) ¼” to ½”
turn until panels are secure. DO NOT OVERTIGHTEN.

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
7 / 8
5. Flip and Install wind guard on fire table.

Round Glass Wind Guard Installation Instructions
SKUS: GWS-25R & GWS-30R
8 / 8
Care and Cleaning
• Clean the glass periodically to remove any build-ups caused by the elements and
combustion. It is recommended that the glass be cleaned 2-3 times during each
heating season, depending on use and environmental conditions.
• Clean using a non-abrasive glass cleaner and a clean lint-free cloth.
• Never Attempt to clean the glass while hot.
• DO NOT touch the glass while in operation or within 10 minutes following use.