QIDI i-mate s User manual

i-mate s
This guide only applies to i-mate s 3D printer

i-mate s

Upper Cover×1
0.2mm Extruder×1
Side Panel×2

4. Remove the protective film on
the outside of the machine.
5. Cut off the cable tie on the
right Y axis.
6. Cut off the cable tie on the left
Y axis.
2. Take out the instructions and
take out the foam.

7. Remove the belt fixing clip of
the X axis.
8. Remove the belt fixing clip of
the right Y-axis.
9. Remove the belt fixing clip of
the left Y-axis.
10. Take out the foam in the di-
rection of the arrow.
11. Move the nozzle out to the
left.
12. Move the nozzle out to the
front and take out the foam.

18. Take out 0.2mm Extruder and
Accessories under platform when
the platform rises to the middle.
17. Click on Z up icon.
14. Plug in the power cord at the
back of the 3d printer’s lower
right corner, then turn on the
power.
15. Click on “Tools”.16. Click on “Manual“.
13. Take out the top cover.