Qooarker W919 User manual

Wireless Wi-Fi Video
Doorbell
Quick Start Guide
Thank you for choosing the product. Please read through the
guide before use, and keep it well for future reference.
Note: Product photos and pictures are for illustration purposes only and
may differ from the real product's appearance. This guide will be updated on a
regular basis with product feature addition or upgrade and the updates will be
included in the new revision printed without notice.

HiSilicon solution; H264 compressed format; High Definition (1.0 MP),
Standard Definition D1, Fluent (VGA) (Optional)
2.8 mm 92° wide-angel lens of military grade, with 2 IR night-vision
LED lights
Support 802.11b/g/n protocol, standard WiFi function, and patented air
packet sending technology for WiFi setting
Built-in ECM MIC and high-frequency speaker; 3D noise reduction and
echo cancellation technology is used to ensure real effect of double-way
Voice intercom
One device may connect to 5 mobile phones/PAD/smart terminals to the
maximum; administrator and visitor passwords may be set for video
intercom, to better guarantee user safety
1
Packing list
After undoing the package, please check whether the visual doorbell (hereinafter
referred to as the “device”) is in good condition, and whether items in the following

list are complete. Should any defect be found, please contact the seller as soon as
possible.
Parts
Model
Power
source
WiFi
antenna
Guide
Screw
kit
W919 DC12V
Power
adaptor
Built-in √ √
2
Installing the doorbell
You can choose the appropriate power supply method depending on the specific
wiring.
The door machine should be installed at 1.5 meters above the ground and there should
be as few obstacles as possible between the installation location and the Wi-Fi router.
1. Separate the back of the doorbell from the doorbell
2. Align to the screw holes on the back of the doorbell and install two screws.
3. Hang the doorbell on the wall. Remove the small round cover on the front top of
the doorbell, and install screws into the wall. Install the small round back. The
installation is complete.

3
Software installation
Install APP
Scan the following QR code. Choose one according to your mobile phone system (as shown
below)
Android IOS
Download for Android: Search in Android Market > yoosee
Download for IOS: iPhone App Store > yoosee Icon
4
Device connection
1. APP account registration

1. Open APP, click Register 2. Select register way. 3. Select a login way to log
into the APP.
Follow the tips to complete registration.
Registration with Phone number is recommended
2. Connection mode: smartlink
First ensure that WiFi signal covers the doorbell installation area. Then check whether
power source and network are connected > Open APP > Create an account and
password > Log in APP > Access to APP
Wait a minute after connection to the power source. A beep prompt tone will be heard
when the device is started, and then smartlink may be used.
(If there is no beep sound, please reset the device. Press the “Reset” key for three
seconds, and the device will give a prompt for successful reset.)
After reset, the device will be restarted (Smartlink may be used for connection only
until a beep sound is heard in one minute after the device is reset)
Open Yoosee > Click “＋” at the top right corner > Click Add new device > Click
smartlink > Enter router WiFi password, Click [Next] > Click Hear a beep for
connection > Click [Next] >
Note: Please put the phone speaker as close as possible to the device microphone.
Check the router password if connection fails, and reconnect it after reset.