QSC LF-3115 User manual

*TD-000172-00*
Cinema Loudspeaker Systems User Manual
LF-3115 Low Frequency Loudspeaker
Introduction
The LF-3115 15” (381mm) low frequency enclosure is designed specifically for cinema appli-
cations. Meeting cinema requirements for extended low frequency response differentiates
the LF-3115 from more conventional “rock-and-roll” woofer systems. The LF-3115 covers the
frequency range from 33 Hertz to 1900 Hertz, depending upon the high frequency system
requirements.
The 300 watt, 15” transducer is well suited for cinema use. It features a 3” (76mm) voice
coil, ceramic magnet, and a multi-vented pole piece to ensure cool operation. Cooler temper-
atures increase transducer lifespan and decrease the problem of power compression at high
power levels. The suspension and voice coil of the transducer have been designed to provide
low distortion and high impact bass at high power.
The enclosure is constructed of high quality medium density fiberboard panels with stiffen-
ing braces on all panels. Both internal and external port openings are fully radiused ensuring
smooth air flow at higher power levels, preventing audible port turbulence. The stiffening
braces reduce panel resonance.
Bass ports are evenly spaced on each side of the transducer, making internal pressure more
uniform across the back surface of the transducer. This prevents the cone from being dis-
placed to one side or another by unbalanced forces, reducing the chance of driving the voice
coil out of the center of the gap at high power.
Three T-nuts in the top of the enclosure provide easy mounting of QSC high frequency sys-
tems, such as the HF-63.
Enclosure is not designed to be suspended, flown, or rigged. Do not sus-
pend, fly, or rig this enclosure.
This product is capable of producing sound pressure levels that can perma-
nently damage human hearing. Always keep sound pressure levels in the
listening area below levels that can damage human hearing.
Install in accordance with QSC Audio Product’s instructions and a
licensed, professional engineer. Only use attachments, mounts, accesso-
ries, or brackets specified by QSC Audio Products, Inc. Refer all servicing
to qualified personnel. Servicing is required when the apparatus has been
damaged in any way.
WARNING! Before placing, installing, rigging, or suspending any speaker
product, inspect all hardware, suspension, cabinets, transducers, brackets
and associated equipment for damage. Any missing, corroded, deformed or
non-load rated component could significantly reduce the strength of the
installation, placement, or array. Any such condition severely reduces the
safety of the installation and should be immediately corrected. Use only
hardware which is rated for the loading conditions of the installation and
any possible short-term unexpected overloading. Never exceed the rating
of the hardware or equipment. Consult a licensed, professional engineer
when any doubt or questions arise regarding a physical equipment installa-
tion.
TD-000172-00 rev.B
© Copyright 2004, QSC Audio Products, Inc.
QSC® is a registered trademark of QSC Audio Products, Inc.
“QSC” and the QSC logo are registered with the U.S. Patent and Trademark Office
1675 MacArthur Blvd., Costa Mesa, CA, 92626 USA
Main Number [phone] Sales & Marketing [phone] or toll free (USA only) [phone]
Customer Service [phone] or toll free (USA only) [phone]
Mounting points for
high frequency system

Connections
Normal Connection
The LF-3115 has barrier strip screw termi-
nals for connection. The terminals accept
up to #10 AWG (5.3mm2) stranded loud-
speaker wiring. Use the largest wire size
and shortest wire length possible for a
given installation. Observe the polarity
markings and keep polarity consistent
throughout the system for best perfor-
mance.
Parallel Connection of Second LF-3115
The terminals marked OUTPUT may be
used to connect another LF-3115 in paral-
lel. Connect the wires as shown in the illus-
tration, at right.
Normal Connection Example:
Parallel Connection Example:
Amplifier capable of
driving 8 ohm loads
Amplifier capable of
driving 4 ohm loads

LF-3115 Specifications (subject to change without notice)
Frequency Range: 33 - 1900 Hertz (-6dB)
30 - 3200 Hertz useable range (-10dB)
Nominal Coverage: 100° horizontal X 100° vertical at 1000 Hertz
Maximum Output: 126.5dB SPL calculated peak, 1 meter, half space, at rated rms power with 6 dB crest factor pink noise input, 35 - 1000 Hertz.
120.5dBA SPL calculated maximum continuous, 1 meter. The dBA scale is typically used to identify sound sources
which can cause permanent hearing loss.
Impedance: 8 ohms nominal
8 ohms minimum, 160 Hertz
90 ohms maximum, 22 Hertz
Maximum Input Power: 300 watts rms (8 hours of 6dB crest factor pink noise, 40 - 400 Hertz)
375 watts rms (2 hours of 6dB crest factor pink noise, 40 - 400 Hertz)
Recommended amplifier power capability- 600 watts rms maximum into 8 ohms (per LF-3115)
Sensitivity: 95.5dB half space, 94.0dB full space, 35 - 1000 Hertz, 1 watt, 1 meter
Recommended Processing: Subsonic filter below 30 Hertz, >18 dB per octave, maximum recommended crossover frequency is 1000 Hertz. QSC
DSP configurations are available at www.qscaudio.com. Parameters for alternative processing hardware are available
upon request.
Connectors: Barrier strip screw terminals accept up to #10 AWG (5.3mm2) stranded wire. Four terminals: (two INPUT and two par-
allel OUTPUT).
Transducers: 15” (381mm) high efficiency low frequency transducer featuring vented 3” (76mm) copper voice coil on Kapton® form-
ers. High excursion/low distortion design, with extremely high power handling, and low thermal and port compression.
Enclosure: Quasi B4 alignment, ported enclosure with fully flared ports, low turbulence symmetrical port design, tuned to 36
Hertz, constructed of medium density fibreboard and heavily braced. Features vandal resistant woofer mounting bolts.
Size: 30” wide X 18” high X 20” deep (762mm X 457mm X 508mm)
Weight: 96 lbs. shipping, 83 lbs. net (44/38 kg.)
SPL and Impedance vs. Frequency, LF-3115
Frequency (Hertz)
SPL (dB)
Impedance (ohms)
SPL 2pi
Impedance
SPL 4pi

Warranty (USA only; other countries, see your dealer or distributor)
Disclaimer
QSC Audio Products, Inc. is not liable for any damage to amplifiers, or any other equipment that is caused by negligence or
improper installation and/or use of this loudspeaker product.
QSC Audio Products 3 Year Limited Warranty
QSC Audio Products, Inc. (“QSC”) guarantees its products to be free from defective material and / or workmanship for a period
of three (3) years from date of sale, and will replace defective parts and repair malfunctioning products under this warranty
when the defect occurs under normal installation and use - provided the unit is returned to our factory or one of our authorized
service stations via pre-paid transportation with a copy of proof of purchase (i.e., sales receipt). This warranty provides that
the examination of the return product must indicate, in our judgment, a manufacturing defect. This warranty does not extend
to any product which has been subjected to misuse, neglect, accident, improper installation, or where the date code has been
removed or defaced. QSC shall not be liable for incidental and/or consequential damages. This warranty gives you specific
legal rights. This limited warranty is freely transferable during the term of the warranty period.
Customer may have additional rights, which vary from state to state.
In the event that this product was manufactured for export and sale outside of the United States or its territories, then this lim-
ited warranty shall not apply. Removal of the serial number on this product, or purchase of this product from an unauthorized
dealer, will void this limited warranty. Periodically, this warranty is updated. To obtain the most recent version of QSC’s war-
ranty statement, please visit www.qscaudio.com. Contact us at 800-854-4079 or visit our website at www.qscaudio.com.
Contacting QSC Audio Products
Mailing address:QSC Audio Products, Inc.
1675 MacArthur Boulevard
Costa Mesa, CA 92626-1468 USA
Telephone Numbers:
Main Number [phone]
Sales & Marketing [phone] or toll free (USA only) [phone]
Customer Service(714) 957-7150 or toll free (USA only) [phone]
Facsimile Numbers:
Sales & Marketing Fax[phone]
Customer Service Fax[phone]
World Wide Web:www.qscaudio.com
E-mail:[email protected]
[email protected]
QSC Audio Products, Inc. 1675 MacArthur Boulevard Costa Mesa, California 92626 USA
©2004 “QSC” and the QSC logo are registered with the U.S. Patent and Trademark Office.
Kapton® is a registered trademark of E.I. du Pont de Nemours and Company.