Quark-Elec QK-A015-TX User manual

Disclaimer: This product is designed to aid navigaon and should be used to augment normal navigaonal
procedures and pracces. It is the user’s responsibility to use this product prudently. Neither Quark-elec, nor
their distributors or dealers accept responsibility or liability either to the product user or their estate for any
accident, loss, injury or damage whatsoever arising out of the use or of liability to use this product.
Email: [e-mail]
V1.0(12/2020)
QK-A015-TX
SET-UP GUIDE
QK-A015-TX
ACTIVE AIS/VHF ANTENNA SPLITTER
BI-DIRECTIONAL -FOR USE WITH TRANSPONDERS
Please recycle your packaging
All products are CE, RoHS cered
More informaon at www.quark-elec.com

This is an overview only. Familiarize yourself with the manual and the manuals of any
connecng devices before installaon. It is always recommended that electronic
equipment be installed by an experienced installer.
Please note: The A015-TX is compable with AIS transponders/transceivers.
(Though the A015-TX can be also be connected to AIS receivers, the A015-RX is sucient for
‘receive only’ applicaons.)
QK-A015-TX
INTRODUCTION
The QK-A015-TX acve antenna splier allows one VHF antenna to be shared between,
1. VHF radio
2. AIS transponder and
3. AM/FM radio
Straight forward connecon to all relevant devices, with no conguraon required.
The A015-TX allows the one VHF antenna to provide:
• Recepon of
• VHF radio
• AIS messages
• AM/FM radio.
• Transmission from
• VHF radio
• AIS messages.
INSTALLATION
The A015-TX has ve connecons:
• Power cable: connect to 12V-24V DC power and GND
• VHF Antenna: SO239 connector for 2-way connecon to VHF antenna
• VHF radio: SO239 connector for connecon VHF radio
• AIS: SO239 connector for connecon to AIS transponder
• AM/FM: BNC connector for the output of the FM/AM radio signal
The A015-TX is a plug and play device. No Conguraon required.
Connect the VHF antenna before connecng other devices!
Connecng powered devices to a Splier without rst connecng the VHF antenna will damage
your devices. Follow the instrucons below carefully and in the right order.
1. Remove power source from the A015-TX
2. Remove power source from all devices to be connected.
3. Connect the VHF antenna to the Splier before adding power or any devices.
4. Connect all other devices (unpowered) to the A015-TX (ie.VHF radio, AIS transponder and
FM/AM radio)
5. Power the A015-TX
6. Power all connected devices (ONLY do this AFTER following the above steps in the correct
order).
7. Checking status LEDs light up when expected.
STATUS LEDS
The A015-TX has four LEDs that indicate power and the Splier’s status.
*VHF fail-safe funcon - VHF radio has full priority and will remain funconal, even in the
unlikely case that the Splier would lose power or fail.
QK-A015-TX
- VHF TX: Transmitting VHF radio *
- AIS TX: Transmitting AIS *
- ERR: Indication errors *
- PWR: indicates power *