2
SUNRISE MEDICAL
TRANSIT KIT INSTALLATION IRIS
B. FRONT TRANSIT BRACKET INSTALLATION
1. Assemble and Place the Front Transit Bracket
a. Place the front transit bracket (A) on the frame location (B) and insert
the hex head screws(C) through the washers into the rocker frame.
b. Slide the washers (D) on the hex head screw and hand tighten the nylock
nuts (E).
c. Finish by tightening the hex-head screws (C) to a maximum torque of
about 120 in-lb.
d. Repeat this process for the other side of the wheelchair.
C. TRANSIT STICKERS
1. The placement of Transit hook location stickers is essential for the safety
of the rider and compliance with WC-19 standards.
a. Peel the backing from the Front Transit Hook decals and place them on
each side of the chair in the location shown in Figure 5.
b. Peel the backing from the Rear Transit Hook decals and place them on
both sides of the chair in the location shown in Figure 6.
C. Peel the backing from the WC-19 Transit decals and place them on both
sides of the chair in the location shown in Figure 6.
D. CHECKOUT
1. Double-check Orientation and Torque on all Hardware.
a. Check that front and rear transit brackets have been installed evenly.
b. Using a torque wrench, check front and rear screws for correct torque.
DEALER/TECHNICIAN WARNING
WARNING
Attention dealers and qualified technicians, do not operate or service this wheel-
chair without first reading the owners manual. If you do not understand the instruc-
tions and warnings in the owners manual please contact the Quickie Technical
Service Department before operating and/or servicing the Quickie wheelchair.
Failure to do so may result in damage and/or injury.
IMPORTANT– Please see the QZ IRIS owner’s manual, and the WC-19
Transit supplement included with this kit, for additional
warnings and information.
65
4