2) SH1T / SH2T
Separate terminal box cover⑧ by loosening terminal box cover
fastening bolt(M5-4EA)⑦ and make sure terminal plate⑥.
3) Wiring Power Line
▪ In case of product using AC voltage, connect the line without
polarity(wire color).
▪ In case of product using DC voltage, black line is negative(-).
4) Treating Cable Terminal
▪ Treat the end of power cable by using “O” or “U” type terminal
for safe wiring.
5) Treating Power Entry
Keep the tightness of power entry⑨ by using water-proof
connector(SH1/SH2-flexible connector #16, SH1T/SH2T-15C
nipple is supplied as a standard specification) or cable grand.
This product is water-proof and anti-corrosion type.
But, install with vertical direction at a place or machine where
exists no big vibration and no strong impact as long as possible.
▪ Refer to below drawing and drill necessary mounting holes on
profitable part of the product.
(Make sure PCD from external view drawing.)
▪ Fix the product by using mounting bolt(M8-3EA).
This product has a volume(1) for controlling revolving speed and
voltage selection switch(2) on assembling board. Refer to
following drawing and explanation for right operating.
1) Lens Set Removal
▪ Refer to wiring diagram of previous page and separate globe
ring(protection cage)② and globe③ from the body by loosening
fixing bolt①(M4 bolt 4ea) and make sure voltage selection
switch(2) and speed control volume(1) on assembling board on
above drawing.
2) Revolving Speed Control
▪ The volume(1) for revolving speed control is built-in this
product. Turn it closckwise for increasing revolving speed and
turn it counterclockwise for decreasing revolving speed.
▪ If give excess power to the volume,it can be broken.
Be careful !
3) AC Voltage Selection (AC Voltage Type Product)
▪ One of AC 110V and 220V can be used by using voltage
selection switch(2). The product is originally produced with
220V as standard specification. So,convert to 110V by using
voltage selection switch if power line voltage is 110V.
4) Bulb Change
※ Warning ! Turn off Power
Must turn off power supply and change the bulb after at least
1 minute.
▪ Make sure the rated voltage and wattage of new bulb. If the
voltage of new bulb is higher than that of original bulb, the
self-life of product can be reduced and can cause damage on
lens and reflector. Therefore, please use same bulb as original
one which has same rated voltage and wattage or lower one.
▪ Bulb Removal : Press slightly the bulb downward and turn it
counterclockwise for removing.
▪ Bulb Fitting : Fit new bulb into the socket by pressing it
clockwise.
Bulb Removing Bulb Fitting
ООО “РусАвтоматизация” 454010 Челябинск, Гагарина 5,
русавтоматизация.рф
Россия, тел. 8 800 775 09 57 , +7(351)799 54 26,
тел./факс +7(351)211 64 57
(звонок бесплатный)
