RadonTec AlphaBlower 2200 User manual

AlphaBlower 2200
Manual
January 2020

RadonTec GmbH
Hauptstraße 5
89426 Wittislingen –Germany
Tel: (+49) 9076 - 919 98 35
E-Mail: [email protected]
Website: radontec.de
Shop: radonshop.com
Version: 01.1 –19.01.2020

3
Manual - AlphaBlower 2200
Table of Contents
1 Introduction......................................................................4
2 Accessories.......................................................................4
3 Technical overview...........................................................5
4 Installation........................................................................6
4.1 Intended use.............................................................6
4.2 Installation instructions............................................7
4.3 User groups ............................................................12
5 LED display & warning signals ........................................14
5.1 Green......................................................................14
5.2 Yellow + warning tone: Service interval reset........15
5.3 Red + warning tone: Cleaning ................................15
6 Symbols ..........................................................................17
7 Declaration of Conformity..............................................18
8 Warranty ........................................................................19
9 Support and Contact ......................................................20
9.1 Troubleshooting/FAQ.............................................20
9.2 Contact Us ..............................................................20

4
Manual –AlphaBlower 2200
1 Introduction
The AlphaBlower 2200 is suitable for installation in a vacuum
pipe system for pumping radon, to reduce radon
contamination in buildings.
2 Accessories
The scope of delivery of the AlphaBlower 2200s includes the
following individual parts:
AlphaBlower 2200
Wall mount
Power supply unit
Cable

5
Manual - AlphaBlower 2200
Connector plug
Screws
Wall mounting material
3 Technical overview
Suction unit
Radon
Voltage
1-phase safety transformer
120 VA / 27 VAC
230 V / 50 Hz
Power
70 W
Max. Vacuum
2200 Pa
Max. Flow rate
130 m³/h
Overvoltage protection
--
Noise level at 1m distance
<40 dB (A)
Dimensions LxWxH
360 x 320 x 200 mm

6
Manual –AlphaBlower 2200
4 Installation
Read these instructions and the enclosed safety
notes completely before commissioning and working
with the device.
Keep these instructions in a place where they are accessible to
all users.
4.1 Intended use
The AlphaBlower 2200 must be placed or mounted on
a stable and solid location in the building.
To reduce condensation problems, the AlphaBlower
2200 and the corresponding piping should be mounted
in heated areas, or the piping must be insulated. Care
must be taken to prevent condensate from running
back into the unit. Condensate running back will
damage the AlphaBlower 2200.
The AlphaBlower 2200 may only be used at room
temperature and indoors. The device must be
protected from excessive moisture and direct sunlight.
The AlphaBlower 2200 must be installed by a specialist
company or a person with the appropriate expertise.

7
Manual - AlphaBlower 2200
4.2 Installation instructions
1. Fix the wall bracket to the wall with four screws.
2. Insert the AlphaBlower 2200 into the holder
4x

8
Manual –AlphaBlower 2200
3. Fix the AlphaBlower 2200 in the holder with 4 screws
4. Installation radon well
4x
Ø 40-60
cm

9
Manual - AlphaBlower 2200
5. Wiring
The mains cable may only be plugged into the mains sockets or
adapters approved for this purpose. Check that the mains
voltage matches the connected load of the aspirator.
Do not use the cable for purposes for which it is not
intended.
Following the installation, the radon concentration must be
measured and a maintenance cycle must be set.

10
Manual –AlphaBlower 2200
6. Possible design variant