RAMTONS RM/317 User manual

KETTLE
INSTRUCTION MANUAL
MODEL: RM/317
Read this manual thoroughly before using and save it for future reference

1
IMPORTANT SAFETY INSTRUCTIONS
·Read all instructions before using.
·Before connecting the kettle to the power supply, check that the
voltage indicated on the appliance (underside the kettle &
base) corresponds with the voltage in your home. If this is not
the case, contact your dealer and do not use the kettle.
·Do not let the cord hang over edge of table counter or touch hot
surface.
·Do not place on or near a hot gas or electric burner or in a heated
oven.
·Do not operate without water, otherwise heater element would be
damaged.
·Ensure thatkettleisused on a firm and flat surface where the
children can’t touch.
This can prevent the kettle from overturning.
·To protect against a fire, electric shock or personal injury, do not
immerse cord, electric plugs or kettle in water or other liquids.
·While water boiling, Avoid to contact with steam from the spout
when water is boiling or just after it has switch off. Do not be
anxious to uncover the lid.
·Always take care to pour boiling water slowly and carefully
without tipping the kettle too fast.
·Be careful when opening the lid for refilling when the kettle is hot.
·Close supervision is necessary when any appliance is used by or
near children.
·Do not touch the hot surface. Use the handle or the button only.
·The kettle is for household use only.
·Do not use outdoors.
·The use of accessory attachments, that are not recommended by
the appliance manufacturer, may result in fire, electric shock or
personal injury.

2
·Unplug from outlet when not in use and before cleaning.Allow to
cool before putting on or taking off parts and before cleaning the
appliance.
·Always ensure the lid is closed and do not lift it while the water is
boiling.
Scalding may occur if the lid is removed during the brewing
cycles.
·If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person
in order to avoid a hazard.
·This appliance has been incorporated with a grounded plug.
Please ensure the wall outlet in your house is well earthed.
·Do not use the appliance for other than intended use.
·The kettle can only use with the stand provided.
·If the kettle is overfilled, boiling water may be ejected.
·This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliances by a
person responsible for their safety.
·Children should be supervised to ensure that they do not play with
the appliance.
·This appliance is intended to be used in household and similar
applications such as:
–staff kitchen areas in shops, offices and other working
environments;
–farm houses;
–by clients in hotels, motels and other residential type
environments;
–bed and breakfast type environments.
·Save these instructions.

3
Description
Lid
Spout
Body
Water gauge
Handle
Lid handle
Switch with indicator
Power base
Before using your kettle
If you are using the kettle for the first time, it is recommended that
you should clean your kettle before use by boiling a full kettle of
water twice and then discarding the water.
NOTE: the max capacity of kettle is 1. L.
Operation of your kettle
1. To fill the kettle, remove it from the power base and open lid by
lifting lid handle, fill with the desired amount of water.
Alternatively, the kettle may be filled through the spout.And
the water level should not exceed max marks or sit below min
max. Too little water will result in the kettle switching off before
the water has boiled.
NOTE: Do not fill the water over the maximum level, as water
may spill out of the spout when boiling. Ensure that the lid is
firmly in place before plugging the power outlet.


4
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Lift up the switch, the
indicator will light up. Then start to boil the water, the kettle will
switch off automatically once the water has boiled.
NOTE ： Ensure that switch is free of obstructions and the lid is
firmly closed ， The kettle will not turn off if the switch is
constrained or if the lid is opening.
4.Lift the kettle from the power base and then pour the water.
NOTE: operate carefully when pouring the water from your kettle
as boiling water may result in scald, besides, don’t open the lid
while the water in the kettle is hot.
5.The kettle will not re-boil until the switch is uplifted again. The
kettle may be stored on the power base when not in use.
Boil-dry protect
Should you accidentally let the kettle operate without water, the
boil-dry protection will automatically switch off the power. If this
occurs, allow the kettle to cool before filling with cold water
before re-boiling.
Cleaning and maintenance
Always disconnect the appliance from the power outlet before
cleaning.
1.Never immerse the kettle, power cord or power base in
water, or allow moisture to contact with these parts.
2.Wipe the appearance of body with a wild and damp cloth
or cleaner, never use a poisonous cleaner.
CAUTION: Do not use chemical, steel, wooden or abrasive
cleaners to clean the outside of the kettle to prevent the gloss loss.
Removal of mineral deposits
Your kettle should be periodically descaled as the mineral deposits
in tap water may form scale on the bottom of kettle so as to cause
the operation less efficiency. You can use the commercially

5
available descaler and follow the instructions on the package of
descaler.Alternatively, you may follow below instructions using the
white vinegar.
1. Fill the kettle with 3 cups of white vinegar, then adding water to
the amount so as to cover the bottom of kettle completely.
Leave the solution in the kettle overnight.
2. Then discard the mixture in the kettle, then filling the kettle
with clean water, boiling and then discard the water. Repeat
several times until the odor of vinegar has been flushes away.
Any stains remaining inside the spout can be removed by
rubbing with a damp cloth.
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local
regulations: hand in the non-working
electrical equipments to an appropriate
waste disposal center.