Randell 2235 User manual

1055 Mendell Davis Drive, Jackson, MS 39272
888-994-7636, unifiedbrands.net
Information contained in this document is known to be current and accurate at the time
of printing/creation. Unified Brands recommends referencing our product line websites,
unifiedbrands.net, for the most updated product information and specifications.
Upright Roll-In Single Door Freezer model 2235
Specifications:
CABINET EXTERIOR: Cabinet body is constructed of all metal,
inside & out. The top, bottom, & back are galvanized steel. Front
and sides are available in finishes as listed above. Door and louver
are stainless steel and are removable without tools. Provided with
stainless steel removable ramp.
CABINET INTERIOR: Interior of cabinet is fully coved to meet N.S.F.
standard #7. Solid core stainless steel interior floor is standard.
The interior walls, ceiling and door liner are available in either
stainless steel or anodized aluminum as listed above. Foamed in
place, CFC free urethane insulation. Snap-in A.B.S. breaker strips
allow access to condensate heater wires. Provided with stainless
steel rack guide.
DOORS: Stainless steel front with either anodized aluminum or
stainless steel liner, mounted on (3) heavy duty cam lift hinges
with heavy duty chrome handle, and cylinder door lock.
REFRIGERATION:Topmountedcondensingunitandevaporatorcoil,
expansion valve system with pressure control, factory tested and
balanced to maintain (0˚ F. to -5˚ F.) average interior temperature
utilizing CFC free 404a refrigerant. Evaporator coil is coated to
resist corrosion. Unit supplied with master on/off switch and 8'
cord and plug. Access to service points without tools is standard.
Provided with full automatic coil defrost with programmable timer
and safety switches.
Description:
Randell Series 2000 Single Section Roll-Ins are built for years of
efficient, high performance service. The top mounted, expansion
valve refrigeration system offers the highest, most consistent
performance available while maximizing usable interior space.
Standard Features:
• Expansion Valve
• Digital Control
• Exterior LED Temperature Display
• Top mounted Compressor & Evaporator Coil
• C.F.C. Free R-404a Refrigerant
• Efficient Hot Gas Condensate Evaporator
• Full Automatic Coil Defrost With Programmable Timer
and Safety Switches
• Cylinder Door Locks
• 8' Cord & Plug
• Main Power Supply Switch
• Self-Closing, Cam Lift Hinges with 120˚ Open Feature
(Lifetime Warranty)
• Triple Hinged Door
• Solid Core Stainless Steel Interior Bottom
• Polyurethane Insulation
• Snap-In Magnetic Door Gaskets
• Stainless Steel Interior Rack Guide
• Condensate Heaters Around Door Opening
• Stainless Steel Removable Ramp
• Fully Coved Interior meeting N.S.F. Standard #7
Standard Series Doors/Louver: Stainless steel.
Exterior Sides: Anodized aluminum. Interior: Anodized aluminum
E Series Cabinet interior, exterior sides, fronts,
and doors stainless steel.
Finishes:
Randell Upright, Page 17
Revised 04/06

Randell, Unified Brands 888-994-7636, unifiedbrands.net
Information contained in this document is known to be current and accurate at the time
of printing/creation. Unified Brands recommends referencing our product line websites,
unifiedbrands.net, for the most updated product information and specifications.
ONE SECTION ROLL-IN FREEZER
* Based on 90˚ ambient and -10˚ evaporator.
Model 2235
FOR REMOTE MODEL
Use same specifications as self-contained model except for:
Model No. Rec. H.P. Rec. BTU/Hr. Amp. Ship Wt.
2235R 1/2 4020 7 830
NOTE:
Unit designed to accommodate one 66" high x 26" wide x 29" deep rack.
Actual rack clearance dimensions: 66 1/2" high x 26 1/2" wide x 29 1/2" deep.
Actual door opening dimensions: 67 1/2" high x 28 1/2" wide.
Model
2235 one section
L
35”
D
34 1/2"
H
84"
Doors
1
HP
3/4
Volt
115/60/1
Amps
12
NEMA
6-15P
BTU/HR
4180*
Ship Wt.
880
Cu./Ft.
33.8
Some models available for -10˚F applications.
Consult factory.
INDUSTRIESCOMPANY
HEATED
HOUSING
EVAPORATOR
CONDENSATE
DRAIN 1/2 "
HOT GAS
OC CONDENSATE
120V/60Hz/1Ph
JUNCTION BOX
COMPRESSOR
9' LONG CORD SET
LEGEND FOR
EH EVAPORATOR
MODEL # 2235
3/4hp
12 Amps
4020 BTU/Hr
J
(NEMA 5-15P)
HP
S/S REMOVABLE
RAMPS
ACTUAL CLEARANCE DIM.
66.5" x 26.5" x 29.5" DEEP
66"H x 26"W x 29"D RACK.
DESIGNED TO ACCOMMODATE
TRIPLE HINGED
ON/OFF SWITCH
THERMOMETER
DOORS 84"
35" 34.5"
HP
EH
OC
J
33"
32.5"