1055 Mendell Davis Drive, Jackson, MS 39272
888-994-7636, fax 888-266-5244
Information contained in this document is known to be current and accurate at the time
of printing/creation. Unified Brands recommends referencing our product line websites,
unifiedbrands.net, for the most updated product information and specifications.
Custom Remote Refrigerated Equipment Stand models 24000AR
Description:
Remote, CFC free, refrigerated cooking equipment stand with
reinforced stainless steel equipment shelf. Integral backsplash
with 45˚ return. Refrigerated drawers on 16 gauge stainless
steel tracks with 1 5/8" stainless steel bearings and removable
plastic pan. 6" high adjustable legs. R-134a cooling system
with evaporator blower coil and expansion valve supplied and
installed.
Shown with optional finished end.
Standard Features:
• Available under one piece top with other modular equipment up
to 16' in length
• 6" high legs—adjustable and movable
• 10 3/8" wide x 1 1/4" thick laminated maple work board
• Self-closing drawers with removable plastic pan
• Evaporator blower coil with expansion valve, solenoid valve,
thermostat, and refrigeration lines provided and installed,
R-134a refrigerant, CFC free
• If unit is fitted with vent, then backsplash will be 3" thick to
meet NFPA 96
• 45˚ integral stainless backsplash is standard. 90˚ stainless
steel backsplash is optional.
• Equipment Rails are optional
Specifications:
EQUIPMENT SHELF: Equipment shelf to be one piece of die-
formed stainless steel with 2" nosing and marine edge. Shelf is
reinforced with welded channel brace assembly.
UNIT BODY: Body ends to be die-formed stainless steel, finished
and polished on the inside, with corrosion resistant exterior. Ends
at top fitted with recessed heavy duty steel bars for splining units
together, producing a hairline seam. Backsplash to be coved
cornered, with 45˚ return at top and overall height of 6 3/4". (If
fitted with vent system, standard backsplash to be omitted and
unit fitted with 3" thick backsplash to meet NFPA 96). 10 3/8"
wide x 1 1/4" thick laminated maple cutting board provided with
removable supports. Base interior to be ABS thermoplastic at
ends only. Stainless steel interior liner to be coved cornered to
form bottom, back and top. Unit insulated with CFC free, high
density polyurethane expanding foam. Units totally prewired to
junction box. Legs to be 6" high stainless steel, with adjustable
bullet foot. Legs mounted to full length channel frame assembly
which is integrally welded to bottom of assembly. Legs can be
moved left to right to avoid floor obstacles during installation.
DRAWERS: Remote refrigerated drawers are located below
equipment shelf. Drawer liners are plastic, removable without
tools, with drawer tracks of 16 gauge stainless steel with 1 5/8"
stainless steel bearings, self-closing. Drawer opening frame to be
ABS and contain magnetic strip for positive sealing of gaskets.
Drawer fronts to be 22 gauge stainless steel with 16 gauge
stainless steel handles, magnetic gaskets, and plastic pan.
REFRIGERATION: Interior fitted with Randell R-134a evaporator
blower coil for cooling base. Expansion valve, solenoid valve,
thermostat, and refrigeration lines provided and installed for
connection at unit rear. Condensing unit and controls not
provided. Units totally prewired to junction box.
Randell Custom, Page 7
Revised 09/04
model 24348AR 24366AR 24378AR 24384AR 24396AR 243102AR 243114AR
