RSSD AR-727H MANUAL 7
DISPLAY MESSAGES
DISPLAY MESSAGESDISPLAY MESSAGES
DISPLAY MESSAGES
Events Screen Layout
Events Screen LayoutEvents Screen Layout
Events Screen Layout
Event Status Code
Event Status CodeEvent Status Code
Event Status Code
A: Indicates the start of a duty period
B: Indicates the end of a duty period
C: Indicates the start of an overtime period
D: Indicates the end of an overtime period
E: Indicates the start of a break period
F: Indicates the end of a break period
G: Indicates user has left the premises
H: Indicates the user has returned to the premises
01: Indicates an erroneous password has been entered
03: Indicates an unprogrammed or invalid card has been presented
04: Indicates a time-zone error
11: Indicates normal access
16: Indicates egress via exit function
17: Indicates an alarm state
31: Indicates an anti-passback error
05/13 12:09:55
16
1616
16
WED 00001 0001
Event Status Code Date Time
Day
User Address
Event Number
10/18 16:42:32
A
AA
A
FRI 00153 1200
Event Messages
Event MessagesEvent Messages
Event Messages
When viewing events, the screen will always show 2 events at a time.
The controller can store a maximum of 1,200 events.
After the 1,200th event, the controller overwrites the messages from event
number 0001 onwards.
Two messages are shown on screen at a time and scrolling up (with F1) or
down (with F2) will take you to the next or previous message.
The messages can be deleted from the controller by performing a factory
reset.
N TICE
N TICEN TICE
N TICE
If a Factory Reset is performed to erase the event messages, all other
If a Factory Reset is performed to erase the event messages, all other If a Factory Reset is performed to erase the event messages, all other
If a Factory Reset is performed to erase the event messages, all other
programming will be lost. Before attempting a Factory Reset make a record
programming will be lost. Before attempting a Factory Reset make a record programming will be lost. Before attempting a Factory Reset make a record
programming will be lost. Before attempting a Factory Reset make a record
of all necessary programming.
of all necessary programming. of all necessary programming.
of all necessary programming.
