Razor POCKET ROCKET Use and care manual

POCKET ROCKET™
BATTERY INSTALLATION INSTRUCTIONS
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
CAUTION: To avoid potential shock or other injury, turn power switch OFF and discon-
nect charger before removing or installing the batteries. Failure to follow these steps in the
correct order may cause irreparable damage.
Figure 1 Figure 2
Step 1
Using a 5mm Allen wrench, remove the three
hex bolts: one located on the bottom and one
on each side of the body fairing. Remove fairing
from the unit.
Using a 5mm Allen wrench, remove the two
hex bolts that hold the seat fairing to the frame
and remove the fairing by sliding it to the rear of
the bike.
Step 2
Tools Required: (Not included)
A. 4mm Allen wrench
B. 5mm Allen wrench
WARNING
Do not use non-Razor products with your Razor electric
scooter. The scooter has been built to certain Razor
design specifications.Certain aftermarket parts may or
may not be compatible.
As with all consumer electronics, use of compatible
batteries and chargers is strongly recommended. Failure
to do so may pose a fire hazard.
Examine the battery, charger and their connectors for
excessive wear or damage each time you charge the
battery. If damage or excessive wear is detected, do not
use the charger or the vehicle until you have replaced the
worn or damaged part.
Battery connectors may contain lead and lead
compounds. Wash your hands after handling.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Figure 5
Using both hands, carefully remove the batteries
from the battery tray. See page 3 for battery care
and disposal information.
Reverse steps:
1. Place the new battery inside battery tray.
2. Re-fasten the battery bracket around the battery
using the two bolts.
3. Reconnect the white battery plastic connector.
4. Reattach fairings on unit using previously
removed bolts.
ATTENTION: Charge unit at least 18 hours
before riding.
Step 5 Step 6
Figure 3 Figure 4
Locate the white plastic connector that leads to
the battery and disconnect by depressing the tab.
Using a 4mm Allen wrench, loosen the two bolts
on the battery bracket and remove the bracket
from the battery.
Step 3 Step 4

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
3
Battery Care
Battery Disposal
Battery Care:
Charge a new battery for at least 18 hours before you use it in
your product for the first time. Never charge the battery longer
than 30 hours. Overheating or undercharging the battery may
shorten battery life and decrease product run time.
After the first charge, recharge the battery for at least 12 hours
after each use. Charge the battery after each use, regardless
of how long the product was used.
Do not allow the battery to run down completely before
charging.
Charge the battery at least once per month, even if the
product has not been used.
Charge the battery before storing the product. Leaving the
battery in a discharged condition can result in a battery that
will no longer take a charge.
Do not store the battery in temperatures above 75°F or
below -10°F.
Charger:
The charger supplied with the scooter should be regularly
examined for damage to the cord, plug, enclosure and other
parts and in the event of such damage, the bike must not be
charged until the charger has been repaired or replaced.
Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally sound manner.
Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not dispose of a lead-acid battery in your
regular household trash. The incineration, land filling or mixing of sealed lead acid batteries with household trash is prohibited
by law in most areas. Return exhausted batteries to a federal or state approved lead-acid battery recycler or a local seller of
automotive batteries. If you live in Florida or Minnesota, it is prohibited by law to throw away lead-acid batteries in the municipal
waste stream.
CONTAINS SEALED LEAD-ACID BATTERY. BATTERY MUST BE RECYCLED.
v2 - 1/10
WARNING: If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a plastic
bag. Refer to the disposal instructions below. If acid comes into contact with skin or eyes, flush with cool water for at least 15
minutes and contact a physician.