RCA Prodigi RDR1520 Series User manual

Communications Systems
RDR1520TM
Digital Radios QUICK START GUIDE
B1520LI
Li-Ion Battery
(2000 mAh)
CH1521
Desktop Rapid Charger
PS1521
Power Supply
BC1520
Belt Clip
Antenna
ANH1520U - UHF models
ANH1520V - VHF models
RDR1520TM
Handheld Radio
What’s Included:
Attaching the Battery: Attaching the Antenna:
Attaching Belt Clip:
Charging the Battery:
Connecting the Charger:
Line up battery guide slots and
slide into place until it locks in.
Plug power supply into the outlet
and connect the other end to
charger base.
Be sure radio is
o, line up screw
threads and twist
antenna clockwise
until it is secure.
Slide battery into the
charging base with or
without the radio attached.
Secure battery in place,
Red LED will be on when
charging.
Align the screw
holes and use a
small screwdriver
to fasten screws.
ATTENTION:
• Remove Battery
• Do Not Use
Power Tool
• Use Screwdriver
Only
Note: Charge a new battery 12 to 14 hours before initial use for
best performance. Maximum battery capacity is normally achieved
after two or three full charge / discharge cycles.

RDR1520 Configuration:
Antenna
Channel Knob
LED Indicator
On/O/Volume Knob
Speaker
Microphone
1
2
3
4
5
6
7
8
9
10
11
12
13
14
*These buttons
are programmable
by your RCA
Communications
Systems Dealer
only upon request
at the time of
purchase.
Download Complete Manual at: RCACommunicationSystems.com/support
RCA and the RCA logo are trademarks of Technicolor SA and are used under license. All other trademarks are the property of their respective owners. © 2020 RCA Communications Systems. All rights reserved.
Screw-On Belt Clip
Push-to-Talk (PTT) Button
Side Button 1*
Side Button 2*
Audio Accessory Connector
Micro-USB (for charging & programming)
Battery
Battery Charging Contact Points
13
24
5
7
6
11
12
13
14
8
9
10
www.rcacommunicationssystems.com
[email protected]
[phone]
Created in U.S.A.