RCP PX03 User manual

Pulse Oximeter PX03 –Quick Start Guide
V1.0 REMOTE CARE PARTNERS PAGE 1
Pulse Oximeter
Quick Start Guide
Model # PX03

Pulse Oximeter PX03 –Quick Start Guide
V1.0 REMOTE CARE PARTNERS PAGE 2
Do not allow other people to use your pulse oximeter. The pulse
oximeter is specifically assigned to you and you only. Allowing
other people to use your pulse oximeter can mislead your
provider.
Taking a Measurement
1. Squeeze the end of the device labeled “PUSH” to open the other
end. Stick one finger completely into the rubber pad cavity of the
Oximeter.
2. Keep the fingernail surface
upward and release the closed
end so the device fits snugly on
your finger.
3. Press the power key to power on
the Oximeter. If you do not
completely insert your finger into
the cavity, the measurement may
be inaccurate.
4. The reading will automatically transfer to the RCP SmartHub and will
then be sent to your provider.
Notes:
•Do not move your finger during the measurement.
•Keep your body still during the measurement.
•The Oximeter will automatically turn off 10 seconds after you
remove your finger.
Understanding the Results - Contact Your Nurse Coach for a more comprehensive
review of your readings
•A normal %SpO2 is 95% or greater.
•A normal Pulse Rate is between 60-100.