
Technical support: www.real-el.com
6
ENG
2.1 USB Multimedia Speaker System
M-370
* You might have to enter “0000” code to connect some models via Bluetooth.
** If an item has been already registered in the device list of sources, then the second search mode activation is
not needed. Choose only the item name and the “connect” command on the source.
Bluetooth mode
• Bluetooth mode requires connection of MMS with a signal source. For this purpose select the
Bluetooth mode using MODE button don the front panel of the subwoofer or PC/BT button d
on the remote control. After 2-3 seconds the speaker system starts the search mode.
• It is necessary to select the search mode of devices with Bluetooth on a signal source (phone,
notebook, smartphone, etc.). “M-370” device will be displayed on the screen which should be
connected to*.
• Indicator light continuously when connection is successful. If there is no connection, indicator
will blink. In this case the system should be switched over to the search mode once again (turn off
and turn on Bluetooth mode)**.
FM Mode
• Use MODE button don the front panel of the subwoofer or FM button jon the remote control
to enter the Tuner mode. The display will backlight the current adjustment frequency.
• Press and hold button eon the front panel of the subwoofer or button fon the remote control
short to auto scan and memorize the found stations. The second pressing of this button before
the scanning is over will stop the auto scanning process. The display a shows the frequency being
scanned, when a radio station is being memorized, the display shows its assigned sequence
number for a short moment.
• For manual scanning, use buttons TUNING -/+ hon the remote control (up/down the frequency
range).
• If preset radio stations are available in the memory, you can switch from one to another by short
pressing buttons band con the front panel of the subwoofer or buttons gand lon the remote
control. You can also enter the frequency or the number of the preset station using numeric pad
buttons con the remote control. The display will show the station number for a short moment and
then its frequency.
“Line input” Mode (AUDIO INPUT)
• Press MODE button don the front panel of the subwoofer or PC/BT button don the remote
control to switch to the PC mode. The display will show PC inscription.
MUTE Mode
• To enter the MUTE mode, press button bon the remote control. To quit the MUTE mode
press the button brepeatedly or press one of the buttons VOL +/- ion the remote control
Note. Due to the constant development of the software, the actual MSS operation may differ from described in
this Manual. The most recent version of the Manual is available at www.real-el.ua