ReBuilder Medical Universal Conductive Garment Socks Installation and operation manual

Questions
For questions about this product...
Call us toll free at
[phone]
Visit us on the Web
www.ReBuilderMedical.com
Or email us at
[e-mail]
636 Treeline Drive, Charles Town, WV 25414
304 - 725 - 2202
304 - 725 - 4915
Universal
Conductive
Garment Socks
Warranty Information
All warranty claims are to be processed by the manufacturer
directly and must be accompanied by a receipt or in your
order history for proof of purchase.
FOR WARRANTY RELATED ISSUES PLEASE CALL
BEFORE RETURNING TO REBUILDER® MEDICAL INC.
For questions concerning warranty, mechanical or
operational problems with your ReBuilder® unit or
accessories, please call toll free 877-717-5487.
ATTENTION
Do not allow the conductive
garments to touch together
when turning on during
treatment or making
adjustments to the intensity of
the ReBuilder® unit.
It is important to carefully
unsnap the lead wire from the
conductive garment after use.
Dry the snap connectors and
the snaps on the garments
before putting them away.
This helps maintain optimal
function of the garments.
NOTE
Even if you have used
Conductive Garments before,
please read these instructions
completely as information may
have changed. MADE IN USA

Using the
Conductive Socks
Please read all the information in this
booklet before beginning treatment
with the Conductive Socks.
Verify the contents of your package:
A. Conductive Garment Socks with
attached snap connectors.
B. ReBuilder® Electrolyte Spray.
A. B.
Care & Cleaning
It is suggested you gently hand
wash the Conductive Socks with
mild soap as needed. Make sure
the snap connectors on the Socks
are completely dry before storing
the Socks in a dry location. Do not
machine wash or dry the Socks.
These products are supplied as extra products for your
convenience. Many physicians will recommend these
garments with use of electrical stimulation devices.
These garments may assist in the treatment for pain
but are not necessary for use with ReBuilder products.
It does not matter if the snap is
on the inside or outside of your
leg.
Color of the snap may vary.
1. Turn the conductive Socks inside out.
2. Holding the Electrolyte bottle about 6
inches away, spray each conductive sock.
3. Apply the Electrolyte spray evenly across
the entire conductive sock until fabric is
moist.
4. Turn the conductive sock right-side out.
5. Repeat spray to the conductive Socks
as necessary to maintain desired
moisture level for your treatments. (More
Electrolyte can be used during treatment,
if needed.)
Putting on the Conductive Socks
Before using, wash your feet with soap
and water. Slide the Conductive Socks
onto each foot. To
reduce stretching,
try to avoid
“pulling” the Socks
on. It is better than
rolling the sock on.
Connecting the Snaps
Snap connectors will
be connected to the
Conductive Socks. Attach
the lead wire from the
stimulator into the snap
connector. (See fig. 2) You
can remove the snaps if it
makes it easier to attach to the lead wire.
Connecting to the Stimulator
Attach your existing lead wire into the
top of your ReBuilder stimulator. Please
note the irregular shape of the output
jack and the end of the lead wire so that
you insert the wire correctly. (See fig. 1)
Insert the metal prongs of the lead wire
into each of the snap connectors.
Rounded
Fig. 1
Fig. 2