6
Safety
The heater has an excellent safety record. It produces safe,
clean, economical heat by using an infrared PTC heating
element. The unique heater uses a process that virtually
prevents wasteful accumulation of heat on the ceiling. These
heaters deliver ultimate comfort by keeping the heat virtually
even from “head-to-toe”.
Zone Heating Control
The heaters provide heat only where and when it is needed.
These heaters are less expensive per heated square foot and
do not require costly duct installation. The heaters use
standard 120 volt current and do not require special 220 volt
wiring or a chimney vent.
Ultimate Comfort
The heaters provide even heat distribution and warm floors.
The heaters thermostatically control, circulate, and recycle
heated air at the floor and maximum use and comfort. The
floor to ceiling temperature differential is minimal.
As the heater operates, you will notice the heater's ability to
heat does not depend on a high-speed flow of air. Instead, the
gentle flow of air promotes more effective heat mixing action
and air stability at the floor.
These heaters will not burn, dry out, or otherwise pollute the
air with impurities. This protects the humidity level and air
quality important to breathing comfort and personal health.
BENEFITS
Healthy Heat
The heaters produce heat that is as safe as the infrared rays
of the Earth's sun, producing natural outdoor heat indoors.
The heater has a low operating and maintenance cost. There
are no burners to rust, corrode, adjust, and no pilot light to
waste energy. A safe, clean, long life ceramic PTC heating
element provides the heat energy. The expected element life
is over 80,000 hours. The heaters are constructed of lifetime
metals (zincification metal plate and Bronze).
Humidifier feature
By adding vapor mist into the direct path of the heaters grill,
the maximum moisture is added to the heaters output. This
synergized addition of a cold mist vaporizer adding moisture
to the infrared heat output dramatically increases the heat
rise and spread as well as producing a super level of
therapeutic comfort especially for children and the elderly.
Photo Catalytic Oxidation (PCO)
Super efficient UVC germ killing chamber combined with
advanced PCO for the ultimate in sanitizing the air passing
through the system for pure clean heated air.
3 Power settings
3 power settings for small/medium/large areas replaces the
need for multiple output heaters for maximum energy savings
in varying space areas.
PERFORMANCE SUGGESTIONS
To assure maximum performance of the heater, please note the following recommendations:
1) For best result, do not locate the heater in an area with a high rate of air filtration and movement as the warm air will be exhausted.
2) Try placing the heater near a warmer inside wall and direct the output towards a cooler outside wall. The cooler outside wall will tend to
draw the generated heat towards itself, which will allow for more efficient heating.
3) Placing the heater next to a cold air return will draw the heat away from area to be heated. Try closing or covering the cold air return.
This will allow for more efficient heating. Experiment with the placement of the heater to see what works best for you.
4) To ensure maximum efficiency, a 40% (minimum) relative humidity should be maintained in the heated environment.
5) The heaters are designed to operate for maximum efficiency up to 80-82 degree range. Due to the soft heat concept, temperatures at 68
degrees feel as though it were 72 degrees. This is due to the heat mixing with humidity evenly for “head-to-toe” comfort.
6) When the heater is placed in an isolated area, i.e. basement or recreation area, the delivery registers and air return grills of the existing
system should be closed in that area if possible.
7) Try placing the heater a few feet above the floor in rooms with large areas of bare concrete. Make sure the heater is secure and won't
fall. This will allow for more efficient heating since concrete acts as a heat sink and will tend to draw the heat in its direction
8) Try lowering your central heating system to a lower temperature and placing the heater in the area you spend the majority of your time.
Now set the heater to your comfort level. After all, there is no point to heating multiple rooms to 68+ degrees when not in use.
9) When heating larger areas, place the heater in a central location. If a ceiling fan is nearby, try using it at the same time to help distribute
the heat evenly. Our suggestion, give it a try and see what works best for you.
10) If used in an extremely dirty or dusty area, the filter must be cleaned more frequently as the filter can clog and cause the heater to stop
working. Please refer to Page 5 in this manual for cleaning instructions.
11) The heater grill is hot when in use. To avoid burns, do not let bare skin touch hot surface. If provided, use handles when moving this
heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least three feet from the front
of the heater and keep them away from the sides and rear.
12) Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and
unattended.
13) To disconnect heater, turn controls to off, then remove plug from outlet.
Always unplug heater when not in use.
