REED KumoSensor Installation and user guide

How to Associate Reed KumoSensor
Step 1. Reed KumoSensors are shipped with battery
installed; but to reduce waste, there is no battery
insulation tape to pull out.
The matching magnet is placed in the opposite
orientation and on the right side in package.
Step 2. Rotate the magnet so that the logo are
aligned in the same orientation, place it on the
left side of the main sensor element.
Step 3. Move the magnet in contact with the Reed
KumoSensor and then away. A LED light should
start ashing for about 2 minutes. Search and
assocaite during that time.

How to Connect DS18B20 External Temperature Probe
Step 1. Open the case by pushing in the snap hook
on both end using a at head screw driver or
a similar tool.
Step 2. Locate the 3 pin terminal block at the edge of
the board and attach the 3 wire DS18B20 probe using
a screw driver. (Note: if the wire is not stripped at
the edge already, you need to use a wire stripper to
expose the copper at the wire edge rst)
Step 3. Close the cap making sure the 3 wires connected
to the terminal passes through the opening in the
cap.
Black
Yellow/White
Red