
Page 1 (1)
User manual /
Assembly instructions
Mug tray
MANUFACTURER: Hantverksdesign & Rehabiliteringsprodukter AB
Tryffelslingan 4, SE-181 57 Lidingö, Sweden
tel. +46 8 767 04 80 fax. +46 8 767 50 00
Parts included:
Assembling
1. Remove the protecting plug from the rear part of the armrest prole.
2. Make sure the screws in the table mount are loosely screwed and then slide the nuts
into the slot.
3. Slide the mount to the desired position and tighten the screws.
4. Replace the protecting plug.
5. Mount the table by inserting the peg in the mount. Use the knob to lock it or to set the
desired feeling for the rotation.
6. Finished!
Use and Care instructions
The mug tray can be cleaned by wiping with soap and water. For further information see Maintenance
Instructions, art. no. 95730-1.
Rev. A
Latest revision: 2012-08-15
Art.no. 95802-1
- Hot beverages should not be used in the mug holder due to the risk for spill that could burn
the user.
- Make sure not to tilt the seat a lot when having a mug in the holder. This since the table will
follow the tilt movement and might cause spill.
!
1 x
1 4
5
2 3
1 x
6