Rejuvenation Mirror Bentwood Floor 30x72 Walnut User manual

Mirror Bentwood Floor 30x72 Walnut
2550 N.W. Nicolai Street, Portland Oregon 97210 Customer Service: 888 401-1900 rejuvenation.com
This floor mirror is meant for floor use only and it is not designed to be hung on a wall. Use of the
provided Anti-Tip is recommended to avoid damage or injury. Installation instructions for the Anti-Tip
kit is below:
PARTS INCLUDED:
Mirror 1 pc
One Anti-tip Kit 2 sets
TOOLS REQUIRED: Phillips screwdriver, pencil, Stud finder.
MOUNTING INSTRUCTIONS FOR TYPICAL DRYWALL APPLICATIONS
Note: Consult your local hardware store for proper mounting to other wall materials.
TOOLS REQUIRED: Pencil / Philips Screwdriver / Stud-finder
1. The anti-tip kit includes one plastic bracket, two
screws and one connecting nylon strap as shown to
the right.
2. As explained below, the bracket must be secured to
a wall stud using the provided screws and the
mirror positioned along the wall so that the
provided strap can connect between the bracket
and the D-ring located on the back of the mirror.
3. For your safety, installation by two people is recommended.
INSTALLATION INSTRUCTIONS:
1) With the help of another person, position the mirror
against a wall at desired location. The mirror should be
placed leaning on the wall so that the bottom of the
mirror is about 4 ~ 6 inches away from the wall. Use a
pencil to lightly mark the wall on each side of the mirror
and then move the mirror aside.
2) Use a stud-finder to determine the stud locations within
the two side marks of Step (1) and mark out the studs
with a pencil. Reposition the mirror at the location and
align the D-rings on the back with a wall stud –you may
need to move the mirror a short distance left or right.
Mark a location on the wall along the stud mark for the
plastic bracket so it is next to the mirror’s D-ring.
3) Vertically position the plastic bracket against wall at the
mark. Use the provided screws and a screwdriver to
secure the bracket to the wall and aligned stud. Rotate
each screw clockwise until tight.

Mirror Bentwood Floor 30x72 Walnut
2550 N.W. Nicolai Street, Portland Oregon 97210 Customer Service: 888 401-1900 rejuvenation.com
4) Finally, carefully move the mirror back to the location and secure the mirror to the wall using the
provided nylon strap. Lace the nylon strap through the bracket and the D-ring as shown, and then
slide the thin end of the strap through the receiving end of the plastic strap. Pull to tighten the piece
of the mirror snug against the wall.
Installation of the Anti-Tip Kit is complete.
*To remove the strap, depress the small level that is located at the ratchet end of the strap and slide
the strap out.
CARE INSTRUCTIONS:
Wipe with a soft, dry cloth.
To protect the finish, avoid the use of all chemicals and household cleaners.
A household glass cleaner may be used to clean the mirror surface, but apply the cleaner to a clean cloth
first and then use the cloth to clean the mirror surface. Avoid spraying the cleaner directly onto the
mirror frame