manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. Rennline
  6. •
  7. Automobile Accessories
  8. •
  9. Rennline DH24 User manual

Rennline DH24 User manual

“RS” style door pull straps
FX 802-893-7311
PH 802.893.7366
EM [email protected]
Order Online: WWW.RENNLINE.COM
READ BEFORE INSTALLATION
The use of any Rennline product is the sole responsibility of the end user. Rennline Inc. accepts no responsibility for
warranty voids or damage resulting from the use of these products. Due to the varying location of wiring harnesses and
other components, carefully inspect any area prior to drilling. All Rennline products are intended for off road use only and
should be installed by a qualified automotive technician.
Check to make sure you have all parts listed prior to installation. If anything is missing contact us immediately.
(2) Handle brackets
(2) 00 Grommets MC86625K31
(2) 8-32 x 5/16” SS Button Head Screw MC92949A191
(2) Handle Straps 4.25”
(2) Handle cover plates
Mini - R55, R56, R57
Step 1: Put window in the down position. Using a screw driver with
tape wrapped around the tip, carefully pry o, (1) armrest, (2) handle
surround (remove small plug at bottom) and the (3) main door card.
See photo for locations. Don’t be afraid, they do all just pull o.
1
23
Step 2: Your door should now look like this.
Step 3: Release the rubber boot on the front of door. Step 4: Remove the (11) torx head screws located all the way around
the door component housing. We have circled 2 of these for you in
the photo above.
Remove plug
For an installation video of this product, go to www.rennline.com and search for P/N DH24, then click the video link.
P/N DH24
Step 5: Remove the (2) torx head screws and the 10mm nut on the
front of the door as shown in the photo above.
Step 6: Remove the (3) torx head screws and bracket on the rear of
the door as shown in photo above.
Step 7: The door component housing should now be free from the
door frame. Lift assembly up a bit and pull the front of the assembly
away from the door about 2 inches as shown in photo above.
Step 8: Wedge a piece of foam board (or equivalent) between the
window glass and the component housing. This will allow you to
release the cable from the back side of the interior door handle.
Step 9: Using a screw driver or small hands (if you have them), release
the handle cable clip from the back side of the interior handle
assembly. Pry it torward the door skin.
Step 10: Remove the (2) torx head screws from the interior handle
assembly and remove it from the component housing.
Step 11: Remove the handle pin and the handle from the assembly
as shown in photo.
Step 12: Install the Rennline handle assembly using the factory pin as
shown above. Note, factory spring will no longer be used.
Step 13: Now do everything that you did in steps 1-12 in reverse.
When you get to the door handle surround, insert the Rennline
handle cover prior to installing it, as shown above. Now move to the
other side of the car.

Other Rennline Automobile Accessories manuals

Rennline ExactFit User manual

Rennline

Rennline ExactFit User manual

Rennline EL13 User manual

Rennline

Rennline EL13 User manual

Rennline RS User manual

Rennline

Rennline RS User manual

Rennline ExactFit User manual

Rennline

Rennline ExactFit User manual

Popular Automobile Accessories manuals by other brands

Magneti Marelli AC161 Installation instruction

Magneti Marelli

Magneti Marelli AC161 Installation instruction

FDI uEZ GUI Start here

FDI

FDI uEZ GUI Start here

JCROffroad JT Install instructions

JCROffroad

JCROffroad JT Install instructions

Rostra VOXXElectronics 250-1930 owner's guide

Rostra

Rostra VOXXElectronics 250-1930 owner's guide

TOP VEHICLE TECH GR3FORD5 installation manual

TOP VEHICLE TECH

TOP VEHICLE TECH GR3FORD5 installation manual

Safe Fleet PRIME DESIGN AR-2000-BLK manual

Safe Fleet

Safe Fleet PRIME DESIGN AR-2000-BLK manual

Skoda Fabia Combi 5J Fitting instructions

Skoda

Skoda Fabia Combi 5J Fitting instructions

Camcar 40077 Al Mounting instructions

Camcar

Camcar 40077 Al Mounting instructions

Camcar 40089 AL Mounting instructions

Camcar

Camcar 40089 AL Mounting instructions

Impac Tradesman 2000 installation manual

Impac

Impac Tradesman 2000 installation manual

DVB OFFROAD BRSB-01 installation manual

DVB

DVB OFFROAD BRSB-01 installation manual

Safari Snorkel SS385HF installation guide

Safari Snorkel

Safari Snorkel SS385HF installation guide

ULTIMATE SPEED 279746 Assembly and Safety Advice

ULTIMATE SPEED

ULTIMATE SPEED 279746 Assembly and Safety Advice

SSV Works DF-F65 manual

SSV Works

SSV Works DF-F65 manual

ULTIMATE SPEED CARBON Assembly and Safety Advice

ULTIMATE SPEED

ULTIMATE SPEED CARBON Assembly and Safety Advice

Witter F174 Fitting instructions

Witter

Witter F174 Fitting instructions

WeatherTech No-Drill installation instructions

WeatherTech

WeatherTech No-Drill installation instructions

TAUBENREUTHER 1-336050 Installation instruction

TAUBENREUTHER

TAUBENREUTHER 1-336050 Installation instruction

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.