Resolution Products RE305 User manual

RE305_DSC_Temp_Instructions Page 1 of 3 16-Ma -14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Wireless
Security
Solutions
RE305 Temp Range, 3-Function, DSC-Compatible
Features
• Freeze, Overheat warnings, plus Magnetic Reed sensor (magnet not
included)
o Can be used as an or all of the functions.
o Unique Electronic Serial Numbers (ESNs) for each function.
• Cover tamper for each ESN Zone.
• Strong, reliable RF signal.
• 8-10 ear batter life on CR123A batter .
• Low Batter indication.
• 3.3x1.4x1.1 inches.
Key Instructions
• Batter “+” faces towards spring.
• Activating Zones
 In order to extend batter life and prevent RF pollution, the unit
comes from the factor with onl the Freeze Zone operating. The
enrolling actions (listed next) activate the Overheat and Reed
Zones.
 ACTIVATE ONLY THE ZONES YOU NEED:
• Enrolling: Place control panel in enroll mode… then for…
 Freeze - Zone 0: ESN ends in “0”:
 Enroll b :
• …installing batter .
 Sensor sends Freeze alarm & enrolls.
 Overheat – Zone 1: ESN ends in “1”:
 Enroll b :
• Holding Tamper down,
• Leaving a magnet awa from Reed Switch,
• …while installing batter .
 Sensor sends Overheat-Alarm & enrolls.
 Reed – Zone 2: ESN ends in “2”:
 Enroll b :
• Holding Tamper down,
• Having a magnet next to Reed Switch,
• …while installing batter .
 Sensor sends magnet alarm & enrolls.
RE305_DSC_Temp_Instructions Page 2 of 3 16-Ma -14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
peration
• Freeze (Freeze ESN)
Alarm: when room temperature drops below 45F.
Tamper: when cover is opened
Supervisor : ever hour
• Overheat (Overheat ESN)
Alarm: when room temperature rises above 100F.
Tamper: when cover is opened
Supervisor : ever hour
• Magnetic Reed (Mag ESN)
Alarm: when magnet is awa from sensor.
Tamper: when cover is opened
Supervisor : ever hour
Specifications
DSC Device T pe: 2 (Door/Window)
Freeze Alarm Temp: 45F +/- 2F
Freeze Restore: when temp increases 4F from alarm
Overheat Alarm Temp: 100F +/- 2F
Overheat Restore: when temp decreases 4F from alarm
Magnet Trip Distance: 1 inch nominal
Mounting hardware: # 4 or #6 screws
Replacement Batter : CR123A 1550 mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.3x1.4x1.1 inches
Specifications subject to change without notice.
Internal Picture
Temp Element
Magnetic Reed
Switch Element
Tamper Switch

RE305_DSC_Temp_Instructions Page 3 of 3 16-Ma -14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Notices
“GE”, “Hone well”, and “DSC” are trademarks owned b General Electric Compan , Hone well
International Inc., and T co Safet Products Canada LTD, respectivel .
Resolution Products, Inc. products will function with one of either GE, DSC or Hone well
s stems. However, no Resolution product is produced b , endorsed b , nor is officiall
associated with GE, Hone well or DSC. Resolution recommends verif ing proper enrollment and
operation, per control panel installation instructions, at installation.
Warrant
Resolution Products, Inc. will replace products that are defective in their first five (5) ears.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
This device ma not cause harmful interference.
This device must accept an interference that ma be received, including
interference that ma cause undesired operation.
Changes or modifications not expressl approved b the Resolution Products, Inc. could
void the user's authorit to operate this equipment.
FCC ID: U5X-RE305
IC Notice
This device complies with Industr Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device ma not cause interference, and
(2)This device must accept an interference, including interference that ma
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE305