Respironics Millennium M10 User manual

Millennium M10
Operating Instructions
Warning: Do not use extension cords or electrical adapters
1. Select a location that allows the oxygen concentrator to
draw in room air without being restricted. Make sure that
the oxygen concentrator is at least ¼ft. away from the
walls, furniture, and especially curtains that could impede
adequate airflow to the device. Keep away from heat.
2. Plug the power cord into an electrical outlet.
3. Connect the oxygen tubing to the oxygen outlet port.
i. You may also att a c h a h u m i d i f i c a tion cup t o t h e
oxygen outlet port. Make sure the cup is filled
to recommended amount and attach cannula to
hummidication cup.
4. Press the power switch to the On ( I ) position. Initially all
the indicator lights will turn on and the audible alarm will
sound for a few seconds. After that time, only the green
indicator light should remain lit.
5. After turning on the Oxygen Concentrator, you can begin
breathing from the device immediately; however, allow at
least 10 minutes for oxygen delivery to reach defined
specifications.

6. Adjust the flow to the prescribed setting by turning the
knob on the top of the flow meter until the ball is centered
on the line marking the specific flow rate.
7. Be sure oxygen is flowing through the cannula. One way to
check is to put the nose piece in a cup of clean water and
see bubbles. If it is not, refer to troubleshooting section.
8. Put the cannula on as directed by your home care provider.
9. When not using the device, press the power switch to the
Off ( O ) position.