Restoration Hardware GRAYSON User manual

GRAYSON FRAMED SLEIGH BED
PARTS INCLUDED
A [1] Headboard
B [2] Side rail
C [1] Footboard
D [10] Cross support Slat
E [1] Center Support Slat
F [1] Center Support Slat Foot (With adjustable glide)
TOOLS NEEDED:
Phillips Screwdriver (not included)
ASSEMBLY INSTRUCTIONS
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
1. Place the headboard (A) on a flat protected surface.
2. Stand the headboard (A) upright and align the Side Rails (B) at the base of the headboard as shown in Diagram I.
3. Insert the Thread Rods (1) into the holes on the of Side Rail (B), and attach Curved Washers (2)
Lock Washers (3), Nuts (4) onto the Thread Rods (1). Repeat for second Side rail.
4. Tighten the Nuts (4) &Thread Rods (1) with Spanner Wrench (5) as shown in the Diagram I.
Page 1 of 2
EDC
B
A
C
NO. HARDWARE & PARTS ENCLOSED Qty
1 Threaded Rod 8pcs
2 Curved Washer 8 pcs
3 Spring Washer 8pcs
4 Nut 8 pcs
5 Spanner Wrench 1 pcs
6 Big Screw (3cm) 20 pcs
7 Big Allen Head Bolt(0.8cm Dia) 2 pcs
8 Small Allen Head Bolt(0.6cm Dia) 2pcs
9 L Shaped Bracket 2 pcs
11 Metal Plate 4 pcs
12 Screw (5cm) 24pcs
The hardware is packed in box 2 with Bed Feet.
10 Allen Wrench 1 pcs

5. Repeat the step 3 and 4 with the Footboard (C).
6. Reinforce the Headboard (A) Footboard (C) and Side Rails (B) with Metal Plate (11) by placing the
Metal Plate (11) onto the connection point and inserting screws (12) as shown in Diagram II.
7. Attach the Cross Support Foot (F) onto the Center Support Slat (E) as shown in the Diagram III.
8. Attach the L-Shaped Brackets (9) to the ends of Center Support Slat (E) and tighten with Allen Head
Bolt (8) & Allen Key (1). Attach the L-Shaped Brackets (5) to the Headboard (A) and Footboard (C)
and tighten with Allen Head Bolt (7) & Allen Wrench (1), as shown in Diagram IV.
9. Place the Cross Support Slat (D) into the cleats on the inside of Side Rail (B), Screw the ends of the
Cross Support Slat (D) to the cleats using Screw (6) in Diagram V.
Diagram I
Diagram II
Diagram IV
F
Diagram III
E
E
F
D
6
D
C
B
A
1
2345
2
3
4
5
10
8
10
7
Thank you for your purchase
Page 2 of 2
www.restorationhardware.com
HEADBOARD/FOOTBOARD
11
12
SIDE
RAIL
Diagram V