Restoration Hardware INDUSTRIAL RIVET LARGE INSET MEDICINE... User manual

BEFORE YOU BEGIN
Do not open cabinet door more than 90 degrees when unit is laying flat on any surface. The weight of the cabinet
door opened beyond 90 degrees in a flat position may cause damage in the hinge areas. Fully open cabinet door
only when in an upright position.
TOOLS AND MATERIALS REQUIRED
1. Screwdriver
2. Carpenter's level
PARTS LIST
A. Cabinet
B. Screws (×4)
C. Glass shelf (×4)
D. Shelf Supports (×16)
MADE IN TAIWAN
INDUSTRIAL RIVET LARGE INSET MEDICINE CABINET ASSEMBLY INSTRUCTIONS
page 1

INDUSTRIAL RIVET LARGE INSET MEDICINE CABINET ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
1. Measure a space for the cabinet body (A). Blocking is recommended to ensure adequate support.
Inset (recessed) box measurements will vary according to cabinet model (See Below).
Dimensions:19-1/4” wide, 33” high, 4” deep
2. Install the cabinet (A) with recessed box set back within the wall cavity.
MADE IN TAIWAN
page 2
WALL

INDUSTRIAL RIVET LARGE INSET MEDICINE CABINET ASSEMBLY INSTRUCTIONS
3. Cabinet can be mounted upside down to open door from the opposite side.
4. Open the door, find screw holes in side panels. Secure cabinet into wood frame with screws (B).
5. Enclosed screws (B) are for wood frame only. Appropriate anchors and screws must be purchased for
installation into non wood frames.
MADE IN TAIWAN
page 3
WALL

INDUSTRIAL RIVET LARGE INSET MEDICINE CABINET ASSEMBLY INSTRUCTIONS
6. Once installed, if the cabinet does not look level at the bottom or top, open the door. By pulling lightly on the
top or bottom of the door, the outer screw of the top or bottom hinge is loosened. Align the door and
re-tighten the screw.
7. If the door is loose, it can be adjusted by tightening the inner screw of the hinge.
MADE IN TAIWAN
page 4

INDUSTRIAL RIVET LARGE INSET MEDICINE CABINET ASSEMBLY INSTRUCTIONS
8. Shelf Instructions. Move shelf supports (D) to the correct prepared holes and insert them.
9. Put the glass shelf (C) on the supports.
10. Repeat with remaining shelves.
CLEANING AND MAINTENANCE INSTRUCTIONS
To maintain and protect luster of all products, clean with soft, damp cloth only.
MADE IN TAIWAN
page 5