Rev-A-Shelf 432 Series User manual

432 Series Filler
Pull-Out Instructions
Step 1. Measure scribe rail thickness and length
per your specic cabinetry. See g 1
Step 2. Install scribe rails to
ller pull-outs using small
nish nails or brads. See g 2
Note: align scribe rails with
front edge of ller pull-out.
Align scribe rail to upper
section of base cabinet lower
mounting strap or lower
section of wall cabinet lower
mounting strap. See gs. 3a–b
Figure 1
Figure 2
Figure 3a
Wall Cabinet
Figure 3b
Base Cabinet
Top Scribe Rail is nailed to
bottom edge of top section
Bottom Scribe Rail is nailed
to edge of bottom section
Top Scribe Rail is
nailed to edge of top
section
Bottom Scribe Rail is
nailed to edge of
bottom section
I-432 6-05

Step 3 (Base Cabinets). Pre-drill 3/16
inch holes 3/8 inch down from top of
cabinet and also 27-3/4” down from
top of cabinet. (See g 4a–d). Repeat
with other adjacent cabinet.
Step 4. Mount ller cabinet pull-out to adjacent
cabinet 1. See Fig. 5a–b
Step 6. Remove front mounting
strap. See Fig 7a–b
Step 7. Attach face frame and onlays (not provided) See Fig. 8–9
Figure 4a Figure 4b
Figure 5a
Step 5. Mount ller
cabinet pull-out to
adjacent cabinet 2.
See Fig. 6
Figure 6
Figure 8 Figure 9
Figure 7a Figure 7b
Wall Cabinet
From inside the adjacent
cabinet screw the 432
cabinet top.
Screw 432 cabinet bottom from
below adjacent cabinet.
Base Cabinet
From inside and above the
adjacent cabinet floor screw
the 432 cabinet bottom.
Screw 432 cabinet top from
above adjacent cabinet.
Figure 4d
Wall Cabinet
Figure 4c
Base Cabinet
Figure 5b
“Changing the way you think
about cabinet organization!”
Questions about installation visit
www.rev-a-shelf.com
or call customer service at
1-800-626-1126
Filler Cabinet
Base Cabinet
Scribe Rail Meets Face
Frame
Filler Cabinet
Base Cabinet
Scribe Rail Meets Face Frame